475723
27
Zoom out
Zoom in
Previous page
1/135
Next page
27
Chain catcher
Â
The chain catcher (30) prevents a broken or jumped off saw
ed.
chain from hitting the operator during sawing.
LCheck the chain catcher on a regular basis and replace
it if it is damag
Silencer / exhaust outlet
Â
Check the tight seat of the screws on the silencer (25) on a
regular basis
Î If they are loose,
tighten them hand-tight with the engine
in cold condition.
Do not retighten the silencer screws when the engine is
t.
ho
L Clean the exhaust outlet on a regular basis
Adjusting the carburetor (idle speed)
the correct fuel-air mixture is fed to the engine.
in severe
engine damages. Do not continue working with the
ed) has to be
in idle speed)
- Err
d
LC d have the carburetor
The carburetor is factory-set to the correct idle speed so that
An incorrect carburetor adjustment results
chain saw in such a condition.
In the cases below the carburetor (idle spe
corrected:
- Speed too high (saw chain continues to move
atic running or lack of acceleration (idle speed too low)
justment to weather conditions and temperatures
ontact a specialist workshop an
- A
adjustment done.
Cleaning
Clean the chain saw thouroughly after each application so that
ith a soft brush or a dry cloth.
the faultless function is kept.
B Clean the case w
Water, solvents and polishing agents shall not be
applied.
Â
B Make sure that the vent slots (32) of the cover (26)
ting).
aw using a
B
and the engine's cooling fins (33) for engine cooling are free
and clean (risk of overhea
B
If heavily contaminated, clean the chain s
commercial chain cleaner.
 Clean the oil flow canal (19) with a clean cloth or a
sh.
bru
B Â
Clean the brake strap (20) at the cover (13) using a
brush.
T
T
r
r
a
a
n
n
s
s
p
p
o
o
r
r
t
t
Before each transport:
switch off device
wait for stop of chain saw
attach the scabbard on the guide bar
 Carry the product with the front handle. The guide bar
l
When transporting the product within a car put it in the boot
o e the chain saw against
tip i
sha l show to the rear side.
or
n a separate loading area. Secur
p ng over, damages and fuel spillage.
S
S
t
t
o
o
r
r
a
a
g
g
e
e
guarantee smooth
operation, before storing for a longer period:
B Operate the engine buretor is empty.
B thoroughly clean th
longer
stem should be flushed
commercial chain saw
the
B Aft
sho
Store unused equipment in a dry, locked place out of the
reach of children.
To extend the service life of the saw and
until the car
e device.
B Empty the fuel tank completely.
B Empty the oil tank completely.
B C Dispose of remainders of fuel/saw chain oil according
to relevant regulations (environmentally compatible).
Tipp:
ncrustations after a
Some chain oils tend to e
period. For this reason the oil sy
a
before a longer storing with
cle
aner. Fill the cleaner up to the middle (appr. 50 ml)
into the empty oil tank. Close the tank. Operate the chain
ithout installed guide bar and chain until all of
saw w
cleaner came out of the oil outlet of the chain saw.
er cleaning, immerse the saw chain in an oil bath for a
rt time and wrap it then with oiled paper.
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Atika BKS 38 A at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Atika BKS 38 A in the language / languages: English, German, Dutch, Danish, French, Italian, Swedish, Norwegian, Finnish as an attachment in your email.

The manual is 6,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info