519909

Atika ATS 250 Manual

17
Zoom out
Zoom in
Previous page
1/80
Next page
15
4. Press the guide piece of the stop rule against the guide
profile on the table (in the direction of the arrow) and lock
the stop in position by pushing the lever down (see
picture).
5. In order to ensure that the stop is actually parallel to the
saw blade, measure the distance from the saw blade at
the front and rear.
Working instructions
Before commencing work, ensure the following:
Protective guard, splitting wedge and saw blade ok?
Saw blade sharp?
Stoppers (fences) ready for use and pushstick to hand?
Workplace tidied?
You may not start to operate the machine until you have
read these operating instructions, observed all the
instructions given and installed the machine as described!
Also, note the following important points:
Place yourself outside of the area of danger
Place your hands flat on the workpiece with fingers closed.
Only guide the workpiece manually up to the front edge of
the protective hood.
Never remove loose splinters, chips, or similar by hand
Ensure that you always comply with the safety
instructions given on p.13 ff.
Cutting narrow workpieces
(Width less than 120 mm)
Push the workpiece forward with both hands, in the area
of the saw blade, use the pushstick (D)
When working on very flat and narrow workpieces (Width
30 mm and less) use the lower guide are of the fence
scale (E), see picture.
Cutting wide workpieces
With the flat of the hand and the fingers closed, push the
work piece to be cut along the stop.
Cross cuts / mitre cuts
Push the transverse stop into one of the guide grooves on
the table.
Set the transverse stop to the required angle and apply the
stop rails (E).
Push the longitudinal stop (C) into the required position, so
that the work piece can be securely held in place.
Place the workpiece to be cut against the stop rails.
Hold the workpiece firmly in place and push it past the saw
blade using the transverse stop. Use the pushing bar if
necessary.
E
C
… 17 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Atika ATS 250 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Atika ATS 250 in the language / languages: English, German, Dutch, Danish, French, Polish, Swedish as an attachment in your email.

The manual is 3,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info