519909
19
Zoom out
Zoom in
Previous page
1/80
Next page
17
Possible faults
Fault Possible cause Removal
Machine fails to start after
switching on or switches off
during idle running
Power failure
Extension cable defect
Motor protecting switch has tripped –
right LED on the control panel is flashing.
Motor or switch defect
Saw blade sticks
Replace fuse
Check cable, no longer use defect cable
Switch motor back on after cooling
”Motor protection”, P. 14
Have motor or switch checked by an approved
electrician or replaced by original spare parts
Remove the cause of the jam.
Machine stops while cutting
Saw blade blunt
Feed too large
Replace saw blade
Allow the motor to cool off and then continue work
using less pressure
Workpiece sticks when
feeding
Saw blade blunt
The longitudinal or parallel stop is not
parallel to the saw blade, see P. 14-15
Hold the workpiece firmly and switch the motor off
immediately. The have the saw blade sharpened or
renew
Readjust the scale, see P.14-15
Burn marks at the cut edges
Saw blade is unsuitable for the cutting
task or blunt
Replace saw blade or have it sharpened
Chip exit blocked
No exhaust suction connected
Suction too weak
Switch off saw and remove chips
See “Safe working”
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Atika ATS 250 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Atika ATS 250 in the language / languages: English, German, Dutch, Danish, French, Polish, Swedish as an attachment in your email.

The manual is 3,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info