lighting
switching on the appliance
First switch the appliance on using the on/off button . The
light above the button lights up. You can now make use of the
other function symbols.
switching on the lighting
Touch the -symbol. The lighting switches on at setting 4.
You can adjust the light intensity (1-4) by keeping your finger
on the button. After a few seconds, the lighting jumps to the
next setting (in the sequence 4-3-2-1-0-1-2-3-4). The number
of indicator lights on above the -symbol indicates the light
intensity.
switching off the lighting
Touch the -symbol and keep your finger on it until the
indicator light above the symbol goes out.The lighting also
goes out if you switch the appliance off using the on/off
switch.
switching on the appliance
Switch the appliance on using the on/off button ( ). The
light above the button lights up. You can now make use of the
other function symbols.
switching on the fan
Touch the -symbol and keep your finger on it until the
setting you want has been reached. If you continue to keep
your finger on the symbol, after a few seconds the setting will
jump to the next setting (in the sequence 0-1-2-3-4-3-2-1-0).
The indicator lamp above the symbol indicates the setting.
fan
GB 2
for your safety
Please note
This appliance should be connected by a
registered fitter. Damage arising from incorrect
connection or incorrect fitting is not covered by
the guarantee.
Disconnect the appliance before starting with
cleaning or reparation. It is recommended that
you do this by removing the plug from the
socket or by setting the isolation switch to zero.
Never flambe under an extractor. The high
flames can cause fire. Even if the ventilator is
switched off.
When deep-frying, always keep a close watch.
If the appliance is used together with
equipment which uses gas or other fuels, then a
sufficient supply of fresh air must be ensured.
Switch the extractor hood on before starting to
cook. After cooking, allow the extractor hood to
continue to run for approx. 10 minutes. This can
also be done automatically (see 'automatic
continued running').
Clean the appliance regularly, as shown in
'maintenance'. This minimises the chance of a
fire starting.
Switch off the electricity before replacing the
light bulbs! Only use the same sort of light bulbs
with the same Wattage.
In view of possible sharp edges on the chimney
we advise you to wear working gloves when
fitting the chimney.
