Manual Ariston E-System One (page 34 of 80) (English)

719961

Zoom out

Zoom in

1/80

34 /

COMMISSIONING

Ignition procedure

Press the ON/OFF button on the control panel to switch on the

boiler. The display shows:

● the operating mode:

winter

summer

Only heating - E-SYSTEM ONE

● The gures indicate:

the ow temperature when no heating requests have been made

- the ow temperature in central heating mode

the temperature of the hot water set in domestic hot water

The carrying out of certain functions is shown:

Deaeration cycle started

Centrl Heating Post-circulation

D.H.W. circuit Post-circulation

Electricity supply

- Check that the voltage and frequency of the electricity supply

correspond to the data shown on the boiler data plate;

- Make sure that the earthing connection is efcient.

First ignition

1. Make sure that:

- The gas valve is closed;

- The electrical connection has been properly carried out.

Make sure that, in any case, the green/yellow earthing wire

is connected to an efcient earthing system;

- Use a screwdriver to lift the cap on the automatic air relief

valve;

- Switch on the boiler (by pressing the ON/

OFF button) and use the

mode button to

select the standby mode, where no hot

water or heating requests are made.

- Start the deaeration cycle by pressing

mode for 5 seconds

The boiler will start a deaeration cycle

lasting about 7 minutes (See below). If

you need to stop it press mode. During the deaeration cycle

open the manual air vent (2) on the heat exchanger and

close when clear water free of air is visible.

- At the end, check that the system is completely deaerated

and, if not, repeat the procedure.

- Bleed the air from the radiators;

- The exhaust duct for combustion products should be suitable

and free from any obstructions;

- Any necessary ventilation inlets in the room should be open

(type B installation).

- Check whether the condense trap contains water; if not, it

must be relled. If necessary, open the manual air vent on

the main exchanger until complete lling.

N.B.: if the boiler will not be used for long periods, the

trap should be lled before the boiler is started up again.

It is dangerous not to rell the siphon as fumes may be

released into the environment.

2. Open the gas cock and check the connection seals, including

the boiler connection joints, making sure that the meter does

not detect any passage of gas. Eliminate any leaks.

3. Start the boiler by selecting the heating or domestic hot

water operation using the

mode button.

Description of Function

Deaeration cycle

During the lling stage or if there is excess air in the system,

the deaeration cycle can be activated by holding the mode

button for 5 seconds. The boiler will start a cycle which lasts

approximately 7 minutes. When this is complete the menu screen

will be restored. The cycle may either be repeated, if necessary,

or stopped by pressing mode. Press the mode button until the

normal display screen is restored.

if the cycle is stopped be sure to

maNually VeNt the appliaNce.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Ariston E-System One in the language / languages: English as an attachment in your email.

The manual is 11,88 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Ariston E-System One

Ariston E-System One User Manual - English - 12 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Ariston E-System One Manual

Product: