160350
20
Zoom out
Zoom in
Previous page
1/30
Next page
E-20
Speaker set-up
This menu screen allows you to specify the speaker
configuration that is connected to the analogue outputs of
your Solo Movie 2.1. It is important that this configuration
reflects accurately the actual situation, otherwise audio
quality may be severely compromised.
The speakers are configured as follows:
Front Left/Right
‘Large’, or full-range speakers can accept audio with the
full frequency range of the source material. With the
Front Left/Right speakers set to ‘Small’, mid- to high-range
speakers will receive a reduced frequency range, with low
frequency information re-routed to the subwoofer. Make
sure that a subwoofer is present if you have set Front
Left/Right speakers to ‘Small’!
Large Front speakers set to ‘Large’ – audio sent with
the full frequency range present
Small Front speakers set to ‘Small’ – audio sent with a
reduced frequency range. This setting requires an
active subwoofer to be present.
Subwoofer
This setting indicates if an active subwoofer is present. If
it is available, low frequency information is routed to the
active device.
None No active subwoofer is connected
Present An active subwoofer is connected
Sub with stereo
This setting controls whether the low frequency
information is redirected to the subwoofer, or not. This
item can be changed only if a subwoofer is specified as
present in the system and speakers are set to ‘Large’.
Off No redirection of low-frequency information
occurs; all the audio is sent to the Front
speakers.
Bass
redirected
Low-frequency information is redirected to the
subwoofer, with the remaining (higher-frequency)
information sent to the Front speakers.
Bass
duplicated
All the audio is sent to the Front speakers.
In addition, the low-frequency information is
duplicated to the subwoofer.
Crossover frequency (Hz)
This setting defines the frequency at which bass-
redirection begins. Frequencies below this level are
redirected from ‘small’ speakers to the subwoofer;
frequencies above this level are not redirected. The
redirection frequency is the same for all the speakers in
a system.
The optimum crossover frequency depends on the
characteristics of your speaker set-up, and is best
determined by experimentation. The setting ranges from
40Hz to 150Hz: we suggest you start at 100Hz.
Trims
Trims for the Subwoofer (and Sub with stereo, if enabled)
can be set in within the range of -10dB to +10dB using
the associated sliders. Adjustment is in steps of 1dB, with
a default of 0dB.
These settings are useful if the speakers have different
sensitivities (and so have different volumes for the same
input levels).
Subwoofer/Sub with stereo trims
Both the ‘Subwoofer’ and the ‘Sub with stereo’ trims
control the subwoofer trim setting. ‘Subwoofer’ is the trim
used when multi-channel material is being played; ‘Sub
with stereo’ is the subwoofer trim used with two-channel
material.
Although Solo Movie 2.1 is very flexible in the
speaker configurations it can handle, some restrictions
have been applied. For example, if no subwoofer
is present, then it is not possible to configure the
speakers to be ‘Small’ since there would be nowhere to
redirect the low frequency information.
If no subwoofer is present, Solo Movie 2.1
automatically turns on Audio compression to prevent
digital clipping in the signal processing.
Completing the set-up
Complete the set-up procedure by pressing SETUP on the
remote control (in DVD mode). This saves all the data and
closes the set-up menus. You can press SETUP at any time
while in a menu to quit from it.
To return to the set-up menus at any time, press the
SETUP button (again, in DVD mode).
Arcam Muso/Logo speakers
When using two Arcam Muso as Front Left/Right
speakers with an Arcam Logo subwoofer – set Front
Left/Right to ‘Small’ and Subwoofer to ‘Present’.
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Arcam solo movie 2 1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Arcam solo movie 2 1 in the language / languages: English as an attachment in your email.

The manual is 1,94 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Arcam solo movie 2 1

Arcam solo movie 2 1 User Manual - German - 30 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info