Mixing amount
-100 ~ 0 ~ +100
Select the setting item "RGHT", "BRAK", or "DOWN"(These setup items are different depend on the master
channel. ST: "RGHT"; TH: "BRAK"; CH3: "DOWN") by pressing “(-)” or “(+)” button. Press “Enter” key, the initial
value of "RGHT", "BRAK", or "DOWN" will blink, Use “(-)” or “(+)” button to adjust the right, brake, or down side
mixing amount.
(Note: In the interface of adjusting the value, return to the initial value "0" by pressing “(-)” and “(+)” buttons
simultaneously for about 1 second.)
Press “Enter” key, the adjusted value stops blinking, the selected mixing amount has been adjusted.
(5) Mixing Mode Setup (MXMD)
OFF, MIX
Initial value: OFF
Select setup item "MXMD" by pressing “(-)” or “(+)” button, press “Enter“ button, the initial mixing mode
“OFF” will blink. Press “(-)” or “(+)” button to switch “OFF” to “MIX”, press “Enter” button, the blinking “MIX”
will stop blinking.
"OFF": Mixing proportional to master channel operation.
"MIX": Mixing by master channel another function considered.
(6) When ending setting, return to the initial screen by pressing “Exit” button twice
4.17 Channel 3 Position „AUX“
The channel 3 and channel 4 servo position can be set from the transmitter. When CH3 is assigned to the
3rd channel key, this setting is linked to the key. When CH3 and CH4 is not assigned to the 3rd channel key,
it can be set with this screen. You can also set the CH3, CH4, CH5 and CH6 as VR at the same time, or SW.
Position Channel 3 (POSI)
SW (LOCK), SW (TACT) or VR (RATE)
Channel 4 Position (POSI)
SW (LOCK), SW (TACT) or VR (RATE)
