Manual Alpina AT2 72 A (page 32 of 54) (English, German, Dutch, French, Italian)

731517

Zoom out

Zoom in

1/54

3. Stop the engine following the

instructions contained in the

machine's Instructions Manual.

5.6 STOPPING THE ENGINE AT

THE END OF OPERATION

1. Place the throttle on «SLOW».

2. Let the engine run at minimum

for at least 15-20 seconds.

3. Stop the engine following the

instructions contained in the

machine's Instructions Manual.

4. With a cold engine, take the cap o

the spark plug (g. 4.A) and take out

the starter key (if applicable).

5. Remove any debris from the engine

and especially around the exhaust

silencer to reduce the risk of re.

5.7 CLEANING AND STORAGE

• Do not spray with water or use pressure washer

wands to clean the exterior of the engine.

• Preferably use a compressed air gun

(max. 6 bars), thus preventing debris

and dust from penetrating inside.

• Store the lawnmower (and the engine)

in a dry place, sheltered from the

elements and suciently ventilated.

5.8 PROLONGED DOWNTIME

If the engine is not going to be used for more than

30 days (for example, at the end of the season),

it will be necessary to take a few precautions

so that it will start back up again accordingly.

• Empty the fuel tank, to avoid deposits from

forming inside, by unscrewing the cap

(g. 5.A) of the fuel tank and collecting

all of the fuel in a suitable container. At

the end of this operation, remember to

screw the cap back on (g. 5.A) tightly.

• Remove the spark plug and pour about 3 cl

of clean engine oil into the spark plug hole,

then, having blocked the hole with a rag, run

the starter motor briey to turn the engine for

a few revs and distribute the oil over the inner

surface of the cylinder. Finally, replace the

spark plug without connecting the cable cap.

6. MAINTENANCE

Any attempt to tamper with the

emission control system may increase

emission levels above legal limits.

This denition includes the removal or

alteration of parts such as the intake system,

the fuel system and the exhaust system.

6.1 GENERAL

The safety regulations that must

be followed during maintenance

are described in par. 2.4.

All controls and maintenance

operations must be carried out with

the machine o and the engine o.

Disconnect the spark plug and read the

relative instructions before starting any

cleaning or maintenance procedure. Wear

suitable clothing, gloves and glasses

before performing any maintenance.

• The frequency and type of procedures

are outlined in the "Maintenance table".

• The use of non-original parts and accessories

could have negative eects on machine

operation and safety. The manufacturer

declines any responsibility for damage

or injury caused by said products.

• Original parts are supplied by assistance

shops and authorised dealers.

IMPORTANT All maintenance and

adjustment operations that are not described

in this manual must be carried out by your

Dealer or by a Specialised Centre.

6.2 MAINTENANCE TABLE

IMPORTANT It is the responsibility of the owner

to perform the machine maintenance operations

described in the table below.

IMPORTANT Clean more frequently when

operating in particularly demanding conditions or

when there is debris in the air.

NOTE Filters should be cleaned / replaced

more often if the machine is used on very dusty

ground.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Alpina AT2 72 A in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 1,87 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Alpina AT2 72 A Manual

Product: