731517

Alpina AT2 72 A Manual

31
Zoom out
Zoom in
Previous page
1/54
Next page
5
5. REGULATIONS FOR USE
5.1 BEFORE EACH USE
Before every use, perform the following 
checking procedures in order to assure a regular 
operation. The fuel characteristics are provided
in the specic paragraph (see 4.2 and 8.1).
5.1.1 Oil level check
1. Place the machine on a at surface.
2. Clean around the oil ll cap.
3. Unscrew the cap (g. 2.A), clean the end 
of the dipstick (g. 2.B) and slide it back 
in until the cap is touching the hole, as
shown, without screwing it back on.
4. Remove the cap with the dipstick and 
check the oil level that must be between 
the «MIN» and «MAX» marks.
5. If oil is required, add oil of the same kind 
up to the «MAX» mark, being careful 
not to spill any outside the oil ll.
6. Fully tighten the llercap (g. 2.A) 
and wipe o any spilled oil.
NOTE Top up gradually, adding small amounts
of oil, checking the level each time.
Do not top up beyond the «MAX» level;
an excessive level can cause:
• smoking from the exhaust;
• soiling of the spark plug or air lter with
subsequent diculty for ignition.
NOTE For the required type of oil, observe the
indications provided in the technical data table.
5.1.2 
The eciency of the air lter is 
essential to correct engine operation;
do not start up the engine if there is no
ltering element or it is broken.
1. Clean around the lter cover (g. 3.A).
2. Take the cover o (g. 3.A) by 
unscrewing the two knobs (g. 3.B).
3. Check the state of the ltering element 
(g. 3.C), which must be intact, clean 
and in perfect working order; otherwise 
service or replace it (par. 6.5).
4. Put the cover back in place (g. 3.A).
5.1.3 Refuelling
The refuelling operations are described in the
machine manual and are mentioned here.
To refuel:
1. Unscrew the fuel cap and take it o.
2. Set a funnel on the hole.
3. Refuel and take the funnel o.
4. At the end of refuelling, screw the cap 
back on and clean any spillage.
IMPORTANT Avoid getting fuel on the
plastic parts of the engine or machine to avoid
damaging them, and immediately clean o
every trace of spilled fuel. The warranty does not
cover damage to plastic parts caused by fuel.
5.1.4 Spark plug cap
Firmly connect the cap (g. 4.A) of the 
spark plug cable (g. 4.B), ensuring 
that there are no traces of dirt inside the
cap or on the spark plug terminal.
5.2 
The engine must be started up as described 
in the machine's Instructions Manual, always 
being careful to uncouple any device (if 
applicable) that is capable of making the 
machine travel forwards or stop the engine.
1. Place the throttle on «CHOKE»
(if applicable) or «FAST».
2. Turn the starter key as described in 
the machine's Instructions Manual.
After a few seconds, gradually 
move the throttle from «CHOKE» (if 
applicable) to «FAST» or «SLOW».
5.3 STARTING THE ENGINE

Follow the entire procedure described for 
cold starts, with the throttle on «FAST».
5.4 ENGINE USE DURING OPERATION
To optimise engine output and performance, 
it must be used at maximum rpm, by 
placing the throttle on «FAST».
IMPORTANT Do not work on slopes
exceeding 20° to avoid jeopardising
correct engine operation.
5.5 STOPPING THE ENGINE
DURING OPERATION
1. Place the throttle on «SLOW».
2. Let the engine run at minimum 
for at least 15-20 seconds.
… 31 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Alpina AT2 72 A at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Alpina AT2 72 A in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 1,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info