541401
42
Zoom out
Zoom in
Previous page
1/134
Next page
42 AR400 Series Router User Guide
Software Release 2.7.1
C613-02021-00 REV F
server is the IP address of the TFTP server the file is loaded from.
When the router has loaded the file into its RAM, it displays the message
File transfer successfully completed”. It then writes the file to FLASH
memory, which takes approximately 30 seconds after the message. Once
the file has been copied to FLASH, you can enter commands that refer to it.
3. Install the new file as the preferred GUI
If you are updating both the release and the resource file, set the preferred
release and restart the router before installing the GUI as described below.
To set the new GUI resource file as the preferred resource file, use the
command:
SET INSTALL=preferred GUI=filename.rsc
You can use the GUI to load the new resource file onto the router
(Management > Software > Upgrade), but you need to use the CLI to
install the new file.
If you disabled the GUI to delete the old resource file, enable it again, using
the command:
ENABLE GUI
Check that the new GUI resource file is valid for your device, using the
command:
SHOW GUI
If it is not, or if the file was corrupted during the download, disable the
GUI, delete the file and try again.
4. Point your web browser at the router’s IP address
Your browser may have a local copy of the old GUI file stored. If so, you
need to delete these temporary files (see “Deleting Temporary Files” on
page 43).
Troubleshooting
The GUI resource file has an 8-digit name, with the file extension rsc (for
example,
d450se01.rsc). To check which resource files are present on the
router, use the command:
SHOW FILE
To see which GUI resource file the router is currently using, and which it will
use on bootup, use the command:
SHOW INSTALL
To display information about the GUI resource file that is currently installed,
use the command:
SHOW GUI
In particular, this command lets you check the file’s validity. If the file is invalid
or damaged, download a new file.
To display information about the router’s HTTP server, use the commands:
SHOW HTTP SERVER
SHOW HTTP SERVER SESSION
42


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Allied Telesis AR450S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Allied Telesis AR450S in the language / languages: English as an attachment in your email.

The manual is 1,66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info