541378

Allen-Heath MixWizard Series WZ20S Manual

16
Zoom out
Zoom in
Previous page
1/32
Next page
16 WZ20S User Guide
Connecting Auxiliary Outputs
AUX6AUX AUXAUX5 4
SENDS
23 AUX AUX 1
AUX 1-6 OUTPUTS Each of the six auxiliary sends is available on a 3 pole TRS jack
socket. These are impedance balanced to reduce noise pickup on long cable runs.
Connect to balanced or unbalanced equipment as shown above. Nominal operating level
is –2dBu but gain is available using the send master control to drive +4dBu if required. Use
pre-fade auxes to feed stage monitor, foldback and cue systems. Use post-fade auxes to
feed effects processors such as reverb, and to provide independent zone, cleanfeed and
recording feeds.
Connecting the Headphones and Local Monitor
R
L
2
TIP = L
RING = R
LOCAL MONITOR OUTPUTS A pair of 3 pole TRS jack sockets provide left and right
outputs from the console local monitor system. These are impedance balanced and can
be connected to balanced or unbalanced equipment as shown above. Nominal operating
level is –2dBu but gain is available to drive +4dBu if required. Independent control is
provided for the local and the headphones monitor systems.
HEADPHONES 2 OUTPUT Two outputs are available for stereo headphones, one on
the front panel, the other on the rear panel. This is convenient for permanent installation
or when two headphones are required at the same time, for example presenter and guest
in a broadcast application. The same signal is available from both. Headphones are
available in many different styles, impedances and volume ratings. To get the best from
your system we recommend that you use high quality closed ear headphones in the range
30 to 600 ohms. 8 Ohm headphones are not recommended.
WARNING Some headphones are more sensitive than others and can
produce higher output levels. To avoid damage to your hearing start with the
PHONES level control at minimum and turn up only as much as is needed to
maintain comfortable listening level. Do not drive headphones at high listening
levels for long periods of time.
… 16 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Allen-Heath MixWizard Series WZ20S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Allen-Heath MixWizard Series WZ20S in the language / languages: English as an attachment in your email.

The manual is 4,94 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info