707374

Alecto WS-3400 Manual

48
Zoom out
Zoom in
Previous page
1/58
Next page
48
Indoor unit:
Slide the battery cover at the rear downwards, insert 2 AA 1.5V batteries as indicat-
ed inside the battery compartment and replace the battery cover on the indoor unit.
(Batteries are not included)
The indoor unit now starts searching for the outdoor unit for 1 minute. Insert the
batteries into the outdoor unit within this minute.
Outdoor unit:
Open the battery compartment by loosening the top of the outdoor unit. Open the battery compartment by
removing the cover. Insert 3 AA 1.5V batteries according to the image above. Pay attention to the polarity (+
and -) while doing so. Replace the cover and secure the top back onto the base (batteries are not included).
Mount the sensor onto a pole (28~40 mm) using the clips with the large screws and bolts.
Preferably, install the outdoor unit at least 1.5m above ground level in an open space within the transmitting
range of the outdoor unit to the indoor unit, making sure it can freely catch the wind.
Remarks:
• After replacing the batteries of the outdoor unit or after an interruption of the connection with the outdoor
unit, press the “SCAN” button on the indoor unit to reconnect the outdoor and indoor unit.
• Avoid placing the unit in direct sunlight, rain or snow.
• Try multiple locations to obtain the best possible reception between the outdoor unit (transmitter) and
indoor unit (receiver).
3.2 Paring the indoor unit / outdoor unit:
Automatically:
As soon as the batteries are inserted into the indoor unit, the indoor unit starts searching a signal from the
outdoor unit for 1 minute. So, when you insert batteries into the outdoor unit within this minute and the units
‘nd’ each other, these units will be paired automatically. The display of the indoor unit shows the tempera-
ture, humidity and wind speed as transmitted by the outdoor unit.
Manually:
If the units cannot automatically nd each other, or after replacing the batteries, you may pair the outdoor
unit with the indoor unit (again) as follows:
1. Press and hold the SCAN button for 2 seconds, the antenna symbol in the display starts ashing
2. Or alternatively briey press the RESET button at the bottom of the outdoor unit
3. After several seconds the units will nd each other (again)
3.3 Location:
Indoor unit:
You may choose to suspend the indoor unit from a wall with a simple screw or to use
it as a desk model with the supplied stand. In any case, never place the indoor unit in
direct sunlight or next to a heat generating light or stove.
Outdoor unit:
You may install the outdoor unit on a pole (excluded). In any case, make
sure to place the unit preferably 1.5 metres above ground level where it
can freely catch the wind.
AA 1,5V
AA 1,5V
AA 1,5V
reset
Not
included
… 48 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Alecto WS-3400 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Alecto WS-3400 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 21,08 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info