Manual Alecto WS-3300 (page 35 of 42) (English, German, Dutch, French)

708524

Zoom out

Zoom in

1/42

chance of frost

When the weather station has received the outdoor sensor’s signal, it’ll automatically switch to the reception

of the DCF-77 atomic time.

2.4 (DCF) time:

When the 

atomic time radio graphically sent by the ‘DCF77’ station, the symbol will remain lit. If this symbol doesn’t

appear, the time is shown via the internal clock of the weather station. The DCF77 station is situated in

Frankfurt, Germany. The reception of the DCF77 time is basically possible in the whole of Western Europe.

During daylight saving time, ‘DST’ will appear underneath the symbol.

2.5 Pairing the weather station / outdoor unit:

Automatically:

As soon as the batteries are installed in the weather station, the weather forecast animation icon starts

flashing. Use the ▼and ▲ buttons on the front panel of the weather station to input the actual weather type.

After 1 minute the weather stations enters the reception mode from the outdoor unit and starts searching

for a signal from the outdoor unit. Therefore, if you insert the batteries into the outdoor unit within that

minute and the units will ‘find’ each other, they will be automatically paired and the display of the weather

station will show the temperature transmitted by the outdoor unit. The weather station will then switch to

the reception of the DCF-77 time signal to synchronise with the station in Frankfurt (see Clock).

Manually:

If the units cannot be paired automatically, or after replacing the batteries, you can pair the outdoor unit

(again) with the weather station unit as follows:

1. press and hold the ▲ button on the weather station for 2 seconds until the

antenna



 

3. the units will have found each other (again) after several seconds

3. POSITIONING THE OUTDOOR UNIT

When the outdoor unit is registered on the weather station and everything is working properly, you may

place the outdoor unit with outdoor sensor (wind and rain sensor) outside.

Because the outdoor sensor and outdoor unit are connected with a cable, the outdoor unit may be placed

closer to the weather station (max. distance 30 meters) or at eye-level to easily read the outdoor unit.

In case of wall-mounting, the weather station and outdoor unit may be suspended from a single screw. You



3.1 Outdoor unit placement tips:

To have the rain and wind meter function as accurate as possible, the rain and wind meter must be placed

exactly horizontal.

3.2 To set the wind meter:

To be able to indicate from which direction the wind is blowing, the rain and wind unit must face the North.

Make sure that the wind vane is aimed to the front (the rear of the wind vane is located above the arm and

closest to the rain sensor. for this, see the “direction for setting wind vane” marking above the rain and wind

meter. Use an accurate compass (not included) to properly aim the unit.

The wind rose will indicate the wind direction. When the outdoor wind meter is installed correctly, the wind

direction may be activated as follows.

Press and hold the “MODE/SET” (30) button for at least 1 second until



Then press the “MODE/SET” (30) 14 times until the wind rose starts

▲ and ▼ buttons to set the North. The settings menu

closes after 15 seconds without pressing any buttons or you may press the

“MODE/SET” (30) button.

Weather conditions:

When the animation indicates rain, but one of the temperature displays is below 0°C,

snow will be displayed in the animation.

Frost alert:

The frost alert icon

will appear in the display when the outdoor temperature is be-

tween -2°C and +3°C.

°C/°F

RESET

OPEN

reset

in line

North

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Alecto WS-3300 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 13,13 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Alecto WS-3300 Manual

Product: