594600

Al-ko AL-KO 142 Manual

32
Zoom out
Zoom in
Previous page
1/124
Next page
Fuelling; Starting / Stopping the engine
ENGLISH 12
6 Fuelling
6.1 Fuel information
A high performance two-stroke engine operated
with a petrol:oil mixture (petrol + oil = fuel mixture)
or with a special fuel mixture for two-stroke
engines available from specialists powers this
machine.
We recommend the proprietary “Aspen 2-takt”
special fuel mixture. Please observe the special
fuel manufacturer’s instructions.
Information on individual mixing of the fuel mixture
Normal or super unleaded petrol can be used for
individual mixing purposes (minimum octane
number 92 RON).
When using a particularly high quality proprietary
2-stroke engine oil such as the “SOLO Profi
2T-Motoröl” which we supply, we recommend an
oil:petrol mixing ratio of 1:50 (2%).
When using other brands of 2-stroke oil we
recommend a mixing ratio of 1:25 (4%).
Only use proprietary 2-stroke engine oil!
Never store fuel mixture longer than 3 - 4 weeks.
Fuel mixture table
Petrol in
litres
Oil in litres
SOLO 2T
engine oil
2% (50 : 1)
Other two-
stroke oils
4% (25 : 1)
1
0.020
0.040
5
0.100
0.200
10
0.200
0.400
Unsuitable petrol or deviations in the mixing ratio
may lead to serious engine damage!
Avoid direct skin contact with petrol and
avoid inhaling petrol fumes - health hazard!
6.2 Fuelling
While fuelling always follow all safety instructions
and take all safety precautions.
Handle fuel only with the engine turned off. Carefully
clean the area around the filler inlet. Place the
machine with the fuel inlet pointing upwards.
Unscrew the tank lid and fill the fuel mixture up to the
lower edge of the filler neck. Use a funnel with filter
to prevent tank contamination. After filling the tank
replace the tank lid and tighten firmly.
7 Starting / Stopping the engine
7.1 Half throttle start position
• Grip the handle; the safety locking key (3) is
activated via the grip area, which also enables
throttle lever (2) to be regulated.
• Press throttle lever fully down.
• Whilst holding the throttle lever down, move stop
switch (1) towards "Start"
( ), and release the
throttle lever.
The part throttle stop is cancelled by brief operation
of the throttle control.
7.2 Choke and primer
Adjust choke as follows:
• With a cold engine, position choke lever (7) up
towards "Close" .
• With a warm engine, position choke lever (7)
down towards "Open" .
When first starting or if the fuel tank has been
completely drained and has been refilled, press
primer (8) several times (at least 5x) until the fuel is
visible in the plastic bulb.
Press the decompression valve (6) every time
before pulling on the starter handle to make the
startup process easier. After starting, the
decompression valve automatically returns to its
normal position.
Fig. 10
Fig. 11
… 32 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Al-ko AL-KO 142 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Al-ko AL-KO 142 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 7,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info