630577
109
Zoom out
Zoom in
Previous page
1/136
Next page
MPC2500 Operators Manual rev 1.0
99
Attack field
You can set the time it takes to start the compres-
sion after the incoming signal exceeds the level set
in the Threshold field.
Release field
You can set the time it takes to finish the compres-
sion after the incoming signal falls below the level
set in the Threshold field.
PHASE SHIFTER
This effect adds sounds with different phases to the
original sound, to create a swelling or rotating sound.
Sweep rate field
You can set the speed of the modulation here.
Offset L/R field
You can set the amount of the phase shift of L and
R. If you set this field to 00, L and R will be in sync.
As you increase the value, the phases of the L and R
will shift and you can create the complicated effect.
Feedback field
You can set the feed back level from the output to
the effect input. The effect will be boosted and cre-
ate more a unique sound.
Sweep width field
You can set the depth of the modulation here.
Mid point field
You can set the center frequency for the phase shift.
If you set this value high, the phase shift will be
applied around the high frequency range.
L/R sweep sync field
If you set it to ON, the Sweep rate will be set at the
same cycle for both the Left and Right. If you set to
OFF, the sweep rate of the right channel will be set
slightly higher than that of the left channel. You will
be able to create a more complicated effect.
TREMOLO
TREMOLO changes the sound level periodically to add
a periodic modulation to the amplitude of sound.
Rate field
You can set the speed of the modulation.
Depth field
You can set the depth of the modulation.
Invert field
You can set the inversion of the L/R modulation.
When set to OFF, both L and R will be modulated
in the same way. When set to ON, L and R will be
inverted to create a more complex effect.
SeqSync field
You can set the Rate (the speed of the modulation)
with the Beat and the Tick of the tempo in the se-
quence. When it is set to ON, the display in the
Rate field will change to Beat and Tick..
FLYING PAN
This effect changes the normal position of the sound
periodically and creates the effect , in which it makes
the sound feel like is is rotating around your head.
Sweep rate field
You can set the speed of the sound rotation. The
higher the value is, the faster the rotation becomes.
Width field
You can set the shift range of the position (move
range). If you set this value higher, the position of
the sound changes more drastically.
Sweep curve bend field
You can set the type of the movement of the position.
Pan low field
You can set how to move the position. If you select
LINER, the position moves horizontally. If you se-
lect ROTATE, the position rotates in circle.
SeqSync field
You can set the Sweep rate (the speed of the sound
rotation) with the Beat and the Tick of the tempo
in the sequence. When it is set to ON, the display
in the Sweep rate field will change to Beat and Tick.
REVERB
This effect adds the reverberation to the original sound,
to give the spatial effect and depth to the sound.
Input filter field
You can set the cut off frequency of the low-pass
filter that you wish to apply to the input signal.
Time field
You can set the length of the reverb. If you set this
value higher, you can enhance the special scope of
the sound.
HF damp field
You can set the quality of the reverb. The lower
value creates harder sounds, and the higher value
creates a softer sound.
Reverb level field
You can set the level of the reverb.
109


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Akai MPC2500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Akai MPC2500 in the language / languages: English as an attachment in your email.

The manual is 12,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Akai MPC2500

Akai MPC2500 Quick start guide - English, German, French, Italian, Spanish - 74 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info