28962
68
Zoom out
Zoom in
Previous page
1/75
Next page
68
FAIL (FAIL SAFE)
The RD6000 Super transmitter provides the capability to program Fail Safe for all six channels. However, Fail Safe is
ONLY available when you are using a PCM receiver and transmitting in the PCM 1 or PCM 2 Modulation mode. If
you are transmitting PPM/FM or PPM/FM-Reverse, you will not be able to enable the FAIL SAFE function.
The Airtronics PCM receivers have the capability to be programmed to respond to RF signal interference by
momentarily holding the last known good command. If the interference lasts longer than one second, then the
receiver’s microprocessor will drive the servos to the preprogrammed positions you previously set-up using the FAIL
(fail safe) function.
To program Fail Safe, you first must select PCM 1 or PCM 2 Modulation for your specific type of receiver.
For example, if you want to set up elevator to occur if interference causes loss of signal at your receiver, select the EL
(elevator) channel on the Channel indicator.
Next, press the FUNCTION down key to access the FAIL screen.
Now position your elevator stick slitely up position that you want for the Fail Safe position. Press the INC +/YES key
to set the position that the elevator servo will be set to upon loss of signal.
To test the action of your preprogrammed Fail Safe, place your elevator stick in the neutral position. Then turn Off
your transmitter power switch. Your elevator servo will go to the fail safe position that you previously programmed.
To return to the INHIBIT condition, press the INC +/YES and the DEC -/NO keys simultaneously.
The same procedure as indicated above applies to setting the Fail Safe positions for the other channels. For
example, if you want to have a small amount of throttle applied during Fail Safe, first select the throttle channel on the
Channel indicator. Then scroll down to the TH Fail Safe screen. Hold a small amount of throttle and press the INC +/
YES key to program the amount of throttle you want for Fail Safe. Test by turning Off your transmiter switch.
NOTE: If interference is present when Fail Safe is not active, in PCM Modulation, the receiver will “hold” the last
command received until the signal is again established.
68


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Airtronics RD6000super at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Airtronics RD6000super in the language / languages: English as an attachment in your email.

The manual is 6,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info