464373

AEG WSP 600 HF Manual

26
Zoom out
Zoom in
Previous page
1/60
Next page
26
For the Fitter
Fig. 7 Upper insulation
●
Pull the connection cords of the heating
elements completely through the openings
prepared and bow the connection cords at the
coloured bushes carefully (Fig. 6).
Caution: Do not push the connection cords
backwards to the interior.
●
Fit the upper insulation mats tightly onto the
cover bricks (Fig. 7).
Caution: Do not mix up upper insulation
during installation!
Inner upper
insulation
15x242x455
Outer upper
insulation
10x270x505
2.3.2 Element Ratings
You can choose from 3 different power ratings.
Connect the heating elements on to the terminal strip X2 depending on the power rating chosen
according to the circuit diagram (page 28). The terminal strip is on the left hand side of the heater
on the inside panel.
Cover up the non-applicable power ratings on the heater rating label (bottom right of heater) with
the label provided (in the bag with the wall-fixing screw) – see example of rating label on page 29.
For this, remove the protective paper from the adhesive side of the label. Position the adhesive side
on the power rating to be covered by means of the frame-outline printed on the rating label. Press
the covering label firmly and then remove the carrier foil. Proceed in the same way for the second
rating to be covered.
Tip: It is easier to cover the rating if the edges of the label are cut off beforehand.
Put a cross against the chosen rating in the circuit diagrams, both in the Instruction Leaflet, and in
the right hand inside panel.
●
Connect the heating elements to the charge control according to circuit diagram (page 28).
Be careful that the capillary tubes do not touch live parts.
●
The heater is then re-assembled as described in Part 1-7 on page 24, but in reverse order.
2.3.3 Disassembly of Fan Drawer
For disassembly of drawer (e.g. for maintenance
works) unscrew the air-outlet grille, release the
inner screws (D) on the right and left side, turn
them off about 15 mm and press them back.
Remove right side panel.
Pull out the fan connection cable and the drawer.
When reassembling the drawer pull back the
connection cable into the lateral control panel
room and tighten the two screws (D) firmly.
See that the drawer does not surpass the bottom
plate of the heater at the front.
Refasten (finger-tight) right side panel and air
outlet grill.
Fig. 8 Disassembly of fan drawer
D
… 26 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AEG WSP 600 HF at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AEG WSP 600 HF in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info