464367
26
Zoom out
Zoom in
Previous page
1/66
Next page
28
Connection to DC control signal (X3) (see circuit diagram page 18)
If a charging control unit with DC control signal (DC voltage 0.91 V-1,43 V) is installed in the
system, the control signal must be connected to the control terminals covered at the factory
”DC +” (plus pole) and ”DC-” (minus pole) (Pay attention to polarity!).
The 230 V AC control signal may not be connected to the ”DC +” and ”DC –” terminals. The
charging control unit would otherwise be destroyed.
Operating and fault indicator (V4) on the electronic charging control unit.
LED lights ”green” no fault
The charging control unit is working perfectly.
LED lights ”red” Fault
a) Selector knob for charging (R1) and/or brick sensor (B1) defective or not connected.
b) Plug-in bridge X17 for charging factor reduction is missing.
No charging takes place.
I
80 % PS
II
80 % NS
III
68/72 %
IV
37/40 %
X15 X14
X13
X12 X11
X10
%PS
% PS
V4
X16
X17
A1
For the Fitter
03 GB WSP_1510S.p65 27.01.2004, 16:3228
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AEG WSP 1510 S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AEG WSP 1510 S in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2,06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info