574019
23
Zoom out
Zoom in
Previous page
1/80
Next page
Non-binding pressure guidelines
Automotive tyre approx. 1.9 – 3.5 bar
Trailer tyre approx. 2.4 – 3.4 bar
Motorcycle tyre approx. 1.7 – 2.9 bar
Bicycle tyre approx. 2.0 – 4.0 bar
Football approx. 0.6 – 1.1 bar
Volleyball approx. 0.18 – 0.22 bar
Attention! Please note the manufacturer
specifications for the item. Do not use the
compressor to inflate swimming aids!
Open the product's valve cover.
Using the valve quick disconnect secure the
correct valve adapter and press it into the item's
valve. If the valve adapter detaches from the
valve whilst inflating, use your hand to press it
into the valve whilst inflating.
Verify the valve adapter is securely connected to
the valve by carefully pulling on it.
As a guide, set the arrow on the manometer
adjusting ring to the desired air pressure
value.
Set the operating switch to ( I ). The unit is
now operational.
To activate the compressor set the compressor
switch on the compressor to ( I ).
Note: the compressor can be switched off at any
time by setting the compressor switch or the
operating switch to ( O ).
Observe and check the firmness of the item
whilst inflating. If the item has already been
overinflated, immediately interrupt the process
and switch the compressor off!
Attention! Excessive air pressure may
cause the item to burst! Risk of personal
injury and property damage!
Once the air pressure marking on the adjusting
ring has been reached, use the compressor
switch to power the compressor off.
Remove the valve adapter from the item's valve
and close the item's valve cap.
First read the product manufacturer's instruc-
tions for inflating and the approved maximum
air pressure before inflating the product.
Do not operate the compressor for more
than 10 minutes. After this time allow the
unit to cool down for 10 minutes!
Inflating sporting goods, toys and recreational
products
As a guide set the arrow marker on the mano-
meter adjusting ring to the desired air
pressure value (see Image 6).
Set the On / Off switch to ( I ). The unit is
now operational.
To activate the compressor set the compressor
On / Off switch to ( I ).
Note: the compressor can be switched off at
any time by setting the compressor switch
or the operating switch to ( O ).
Once the air pressure marked on the ad-
justing ring has been reached, switch the com-
pressor off using the compressor switch .
To do so, set the compressor switch to ( O ).
To switch off the unit the operating switch on
the unit must be switched off.
Open the valve quick disconnect and remove
the auto valve connector from the tyre valve.
Also check the air pressure with a second
pressure gauge to determine the accurate value.
Repeat the process if the desired air pressure
has not been reached.
Then replace the valve cap on the tyre valve.
Image 6
Mark air pressure
value e.g. 2 bar
5
13
19
5
19
4
13
19
4
5
13
19
19
13
5
19
13
19
GB 23
5
97180_Luft-Energiestation_LA_10_Manual _01_08_2012_print
Mittwoch, 1. August 2012 12:30:07
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AEG LA 10 - 97180 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AEG LA 10 - 97180 in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 3,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info