648419
14
Zoom out
Zoom in
Previous page
1/48
Next page
14
Operation – Installation
4.3 Restricting the control switches
At the rear of the operating unit there are 3 pins with which
you can x or restrict the settings of the sliding switch and
temperature control knob.
D0000047393
1 2
1 Temperature selector
2 Sliding switch
P Pin holder
B Fixing the temperature control knob to a specic
temperature
L Restricting the temperature control knob to a specic
temperature range
M Fixing the sliding switch to a specic operating mode
5. Cleaning, care and
maintenance
The appliance contains no user serviceable parts.
» Clean the appliance when cold with ordinary clean-
ing products.
» Avoid abrasive or corrosive cleaning products.
» If a pale brownish discolouration appears on the ap-
pliance casing, wipe it off with a damp cloth.
» Regularly clean the upper and lower ventilation
grilles of the appliance with a vacuum cleaner.
!
Material losses
Never spray cleaning spray into the air slot.
6. Troubleshooting
Problem Cause Remedy
The appli-
ance does
not heat
up.
The temperature is set
too low.
Check the temperature set on
the appliance.
The power supply has
been interrupted.
Check the MCB/fuse in your
fuse box/distribution panel.
The appliance has
overheated. The high
limit safety cut-out has
switched the appliance
off.
Remedy the cause, such as
a covered or dirty air outlet or
intake.
After a few minutes of cooling
down the appliance will restart.
If you cannot remedy the fault, notify your qualied con-
tractor. To facilitate and speed up your request, provide
the number from the type plate (000000-0000-000000).
INSTALLATION
7. Safety
Only a qualied contractor should carry out installation,
commissioning, maintenance and repair of the appliance.
7.1 General safety instructions
We guarantee trouble-free function and operational relia-
bility only if original accessories and spare parts intended
for the appliance are used.
7.2 Instructions, standards and regulations
Note
Observe all applicable national and regional regula-
tions and instructions.
8. Appliance description
8.1 Standard delivery
The following are delivered with the appliance:
Wall mounting bracket
8.2 Accessories
8.2.1 Further accessories
Control unit
9. Installation
9.1 Installation site
WARNING Electrocution
Install the appliance in such a way that the control
equipment cannot be touched by a person in the
bath or shower.
!
Material losses
Fit the appliance to a vertical wall that is heat-resist-
ant to at least 85 °C.
!
Material losses
Never install the appliance directly below a wall
socket.
!
Material losses
Maintain the minimum clearances to adjacent sur-
faces.
≤500
≥150
≥500
≥120
≥175
D0000047392
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AEG KLE 502 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AEG KLE 502 in the language / languages: English, German, Dutch, French, Polish as an attachment in your email.

The manual is 8,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info