361354

Aeg-electrolux cp 2200 Manual

42
Zoom out
Zoom in
Previous page
1/132
Next page
g
42
The ejector lever flips in and the cof-
fee-making unit closes.
Inserting the coffee-making unit
0 Follow these steps to re-insert the cof-
fee-making unit:
1. Push the coffee-making unit onto the
guide bar and then unit into the coffee
machine as far as it will go (Fig. 36).
2. Press the latching button down and
slide the coffee-making unit back for
around another 1 cm until the latching
button engages (Fig. 37).
3. Press the latching lever down to the
stop (Fig. 37).
0 Replace and close the service cover,
and re-insert the coffee grounds con-
tainer.
3
The coffee machine can be switched on
only when the service cover is closed.
After the coffee machine has been
switched on, the coffee-making unit
runs through the set-up cycle, and this
is followed by the normal heating pro-
cess.
15.6 Running the Cleaning Program
The cleaning program permits the
intensive cleaning of otherwise inac-
cessible locations. Run the cleaning
program no later than when the
"Clean" key (Fig. 3, f) indicator
flashes.
The cleaning process lasts around
8 minutes and should not be inter-
rupted.
3
Use only original AEG-cleaning tablets!
These can be obtained through the
AEG Serviceline (ET No. 663 910 480) or
your dealer (E No. 950 078 803).
0 Before starting the cleaning program,
clean the coffee-making unit (refer to
„Cleaning the Coffee-making Unit"
page 41) and empty the coffee grounds
container. Fill the water tank with at
least 1 litre fresh water.
0 Press the "On/Off" key (Fig. 3, h) to
switch the coffee machine on.
0 Turn the coffee bean container to the
"Ground Coffee" position (Fig. 38).
Wait until the mechanism has set up
and all the lights of the Coffee Quan-
tity indicator are extinguished.
0 Pull the emptied grounds container out
until it is under the coffee dispenser
(Fig. 39).
It is used to collect the cleaning liquid.
The "Empty grounds container" indica-
tor (Fig. 3, j) comes on and remains
illuminated for as long as the grounds
container is pulled out.
0 Place a cleaning tablet in the ground
coffee filler (Fig. 40).
0 Press the "Clean" key (Fig. 3, f) for
around 3 seconds. The indicator
changes from flashing to constantly
on. The program starts. The cleaning
program must not be interrupted.
3
During the cleaning process, the
"Empty grounds container" indicator
(Fig. 3, j) is illuminated, and the
Coffee Quantity indicators are illumi-
nated alternately. The program runs six
cycles with cleaning liquid. The stand-
ing times are used to allow the clean-
ing tablet to penetrate. In the event of
a power failure or interruption, the
program must be restarted!
The cleaning process finishes after
approximately 8 minutes, when the
Coffee Quantity indicators are extin-
guished and the "Empty grounds con-
tainer" indicator (Fig. 3, j) flashes.
0 Empty the coffee grounds container
and re-insert it. The indicator light
now goes out.
0 Turn the coffee bean container to the
desired position and fill the water tank.
The coffee machine is now ready for
use.
3
After running the cleaning program,
you are advised to throw away the first
cup of coffee from the machine.
15.7 Running the Descaling Program
The descaling program allows you to
simply and effectively descale your
coffee machine. The coffee machine
must be descaled when the "Descale"
key (Fig. 3, e) indicator flashes, at
the latest however after 4 months.
822_949_318 CP2..._defnep.book Seite 42 Freitag, 2. November 2007 6:30 18
… 42 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Aeg-electrolux cp 2200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Aeg-electrolux cp 2200 in the language / languages: English, German, Dutch, French, Portuguese, Spanish as an attachment in your email.

The manual is 6,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info