541310
84
Zoom out
Zoom in
Previous page
1/177
Next page
6.17 Compressor 84
6.17 Compressor
The Compressor module is used to automati-
cally compress or expand the dynamics of a signal.
This module has two inputs and one output. The
first input is the signal to be compressed and the
second input is a control signal which triggers the
compression process when it rises above a given
threshold. This control signal is usually the same
as the input signal.
The gain in slider is used to adjust the level of both the input and control signal. The gain
out slider is used to adjust the output signal of the unit. The attenuation level meter indicates the
amount of reduction due to the gain reduction unit. It displays the difference between the level of
the input signal multiplied by the input gain and the signal level after the compression. The level
meter shows the level of the signal after the input gain or after the output gain depending on the
position of the source button. The threshold and ratio knobs are used to control the behavior of the
compression unit. The threshold button sets the level above which the gain reduction occurs while
the ratio knob is used to adjust the ratio of compression to values ranging between 1:1 and 1:30.
The attack and decay knobs set the amount of time it takes for the unit to respond to the variation
of the control signal. The attack time is used when the control signal is above the threshold while
the decay time is used when the control signal is below the threshold. Finally the bypass control is
used to bring the compressor in or out of the audio chain. Note that this control has no effect on
the output gain control which is always active.
6.18 Constant
The Constant module has 1 output, a constant value (DC) which is set during construction. This
module has no input and no front panel control. To change the value of the constant in the Tassman
Player, use the Constant module in combination with a Volume module. Its value can be positive
or negative.
Typical Use
In the following example, the pitch of a Plate module is fixed to a constant value. The value of the
constant is adjusted with the Volume slider.
The default value of the following parameters is set during construction
Output value: value of the constant.
84


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AAS Tassman 4 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AAS Tassman 4 in the language / languages: English as an attachment in your email.

The manual is 1,79 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info