671757
18
Zoom out
Zoom in
Previous page
1/28
Next page
18
17
2.3 Removing and
replacing the control
panel front cover
Removing the cover (see gure 7)
1. Remove the screw at the top centre of
the control panel.
2. Push the cover upwards until the
hooks at the lower end clear the
burner access opening and base tray.
3. Pull the lower end of the cover slightly
forward.
4. Pull the cover down until the top edge
is clear of the control panel and then
remove.
Replacing the cover (see gure 7)
1. Place the top of the cover inside the
rim of the control panel and push it up
as far as possible.
2. Position the bottom hooks inside the
burner access opening and over the
rim of the base tray.
3. Push the cover downwards until the
lower hooks engage and the top
screw holes align.
4. Replace the screw in the top centre
of the cover.
2.4 Setting the gas pressure
The gas pressure has been set to the
correct values at the factory.
Important: The following procedure
must be followed when checking or
setting the gas pressure:
1. Shut down the heater by switching
off the mains current (switch off main
switch);
2. Connect a manometer to the pressure
test nipple to measure the burner
pressure on the gas control.
3. Activate the heater and allow the
burner to ignite;
4. Check the burner pressure. If
necessary, reset it by means of the
burner pressure adjusting screw.
Turning it anti-clockwise reduces
burner pressure. Turning it clockwise
increases burner pressure;
5. Shut down the heater, remove the
manometer and close the pressure
nipple;
6. Restart the heater (test for
soundness).
Figur 7 taking off and mounting the
control panel
AOS 1130
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for A.O. Smith BTI 100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of A.O. Smith BTI 100 in the language / languages: English as an attachment in your email.

The manual is 0,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info