503290
43
Zoom out
Zoom in
Previous page
1/64
Next page
Instruction manual ADM 43
gis
8 Status of the
appliance
8.1 Introduction
Topics covered in this chapter, in sequence:
Operating modes
;
Error conditions
.
8.2 Operating modes
When running, the appliance has three basic
operating modes, namely:
ISOLATED
In this mode the appliance is off and all
components are electrically dead.
- The isolator (switch between the appliance
and the power supply) is turned off.
- On the control panel, the on/off switch is at
position 0.
OFF
In this mode, the frost protection is activated.
- The isolator is set to position I.
- On the control panel, the on/off switch is at
position 0.
ON
In this mode the appliance continuously fulfils
demand.
On the control panel:
- the on/off switch is in position I.
- The water temperature can be set using the
rotary button on the control
thermostat (7.3 "
Control thermostat").
8.3 Error conditions
If the appliance has an error, heat demand will be
(temporarily) ignored. There are various types of
errors, divided into three groups:
Gas control lockout errors
In this case the gas control's safety valve is closed,
as a result of which the pilot flame is extinguished.
Once this error has been rectified, the pilot flame
must be re-lit (9.2 "Starting the appliance").
Blocking errors
In this case the gas control's main valve is closed.
Despite a possible demand, combustion is
stopped although the pilot flame remains ignited.
These conditions disappear automatically once
the cause of the error has been eliminated. The
appliance then starts running again
spontaneously.
Lockout error from the flue gas thermostat
This error condition has much the same
characteristics as a 'Blocking error'. The difference
here is that the lockout (push button) for the flue
gas thermostat in the draught diverter is
activated (7.3 "
Control thermostat"). After
removing the cause, the push button must be
pressed to re-start the appliance.
The cause of the error cannot be seen on the control
panel. For a detailed overview of error conditions,
please refer to the 'Errors (11 "
Troubleshooting")'.
If you as an end user come across the appliance when
it is in an error status, you can attempt to start the
device up (9.2 "Starting the appliance").
However, if the error returns or occurs several times in
a short time, you must contact your service and
maintenance engineer.
43


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for A.O. Smith ADM 50 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of A.O. Smith ADM 50 in the language / languages: English as an attachment in your email.

The manual is 1,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of A.O. Smith ADM 50

A.O. Smith ADM 50 Usermanual and installation guide - Dutch - 68 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info