This is an example for inserting the RFX-1100 between the sound source and a playback system or multi-track recorder
(MTR). A stereo source should be connected to the INPUT L/MONO and R jacks. A mono source should be connected to
the L/MONO jack only.
In this example, the signal from the mic or the instrument is effect processed by the RFX-1100 and then sent to the
playback system or MTR. The balance between original sound and effect sound is adjusted at the RFX-1100.
Insert Connection
Basic Connections
The RFX-1100 is compatible with international 19-inch rack standards (EIA, DIN). Because the unit has been designed
for rack installation, it is preferable to operate the unit in this way, rather than simply placing it on a table or similar.
Align the four screw holes with the rack screw holes and securely fasten the unit to the rack with screws.
• The RFX-1100 uses a metal frame,
making the unit heavier than it might
seem at first glance. While installing the
unit in a rack, carefully support the
weight of the unit until all screws are
securely tightened. Otherwise the unit
may drop, possibly causing injury to
persons or damage to itself or to other
equipment.
• Do not directly stack the unit on top of
other equipment. Otherwise heat may
lead to a fire risk or cause performance
degradation.
• Before installation, always unplug any
connecting cables and the power cable.
Otherwise the equipment or the cables may be
damaged.
• Make sure that the rack in which the unit is
installed is placed on a firm, solid surface, so
that it cannot shake or topple over. Otherwise
there is a risk of injury to persons or damage
to the unit or to other equipment.
Rack Mounting
Getting Connected
Rack Mounting / Getting Connected
