666301
15
Zoom out
Zoom in
Previous page
1/16
Next page
15
ZOOM RFX-1100
No sound or very low
volume
• Is sound source connected correctly to
INPUT jacks and are OUTPUT jacks
connected correctly to playback system?
Follow the instructions in "Getting Connected".
• Is a microphone connected to the rear-
panel INPUT jack?
Connect the microphone to the front-panel MIC
IN jack.
• Are effects turned off and is the MIX control
fully turned to the WET position?
Turn the MIX control towards DRY.
• Are all shielded cables used for the
connection okay?
Try replacing the shielded cables.
Follow the instructions in "Trying Out the
Effects" and adjust the controls properly.
• Are the connected sound source and
playback system operating normally? Is the
volume set to a proper position?
• Are INPUT control and OUTPUT control of
RFX-1100 set properly?
The sensitivity of the MIC IN connector is
optimized for microphones. Connect line-level
devices to the rear-panel INPUT jacks.
• Is a line-level device such as a synthesizer
connected to the front-panel MIC IN
connector?
Check all components and set the volume to a
suitable position.
Input sound breaks up
or is distorted
• Is input signal level too high?
Adjust INPUT control so that CLIP LED does
not light at signal peaks.
No effect sound
• Is incorrect foot switch connected?
Use only ZOOM FS01.
• Were effects turned off with foot switch
FS01 connected to rear panel?
Press foot switch again to turn effects on.
Symptom Check Remedy
• Is MIC ON/OFF switch set to OFF?
To use a microphone connected to the MIC IN
connector, the MIC ON/OFF switch must be set to ON.
Preset programs
363
(11 effects x 3 banks x 11 variations)
Sampling frequency
44.1 kHz
A/D converter
18 bit, 64 times oversampling
D/A converter
18 bit, 8 times oversampling
Inputs
Line input 2 x standard mono phone jack
Input impedance 10 kiloohms (mono),
20 kiloohms (stereo)
Reference input level -10 to +4 dBm
Microphone input XLR-3-31/standard phone combo jack
(Balanced operation) Input impedance
4.5 kilohm, pin 2 hot
(Unbalanced operation) Input
impedance 50 kilohms
Reference input level -56 dBm
Outputs
2 x standard mono phone jack
Output impedance 500 ohms
Reference output level -10 to +4 dBm
Control input
FS01
Dimensions
482 (W) x 115 (D) x 44 (H) mm
Weight
1.8 kg
Supplied accessory
Power cord
* 0 dBm = 0.775 Vrms
* Design and specifications are subject to change without notice.
Troubleshooting
Specifications
RFX-1100 Effects / Troubleshooting / Specifications
11.
VOCODER
VARIATION
REVERB TIME/ADJUST
Mode &
Character
Sensitivity
This effect lets you use a mic connected to the MIC IN jack to control the
signal from a synthesizer supplied to the INPUT L jack. The signal
supplied to the INPUT R jack is mixed with the MIC IN signal and can also
be used as control signal.
To use this effect, turn the MIX control fully to WET.
Selects the number of filter bands for the
VOCODER and the sound character.
Adjusts the VOCODER
sensitivity.
Low sensitivity
High sensitivity
1
VOCODER only
2
+ chorus
3
+ distortion + chorus
4
VOCODER only
5
+ distortion
Fast attack
Slow attack
18 bands
6
VOCODER only
7
+ chorus
8
+ distortion + chorus
VOCODER only
+ chorus
+ distortion + chorus
9
10
11
Fast attack
Slow attack
10 bands
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zoom RFX1100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zoom RFX1100 in the language / languages: English as an attachment in your email.

The manual is 1,69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info