If the unit detects that both a CD-R/RW drive and another
SCSI device are connected, a screen to select the restore
source appears when you press the [ENTER] key in step 4.
Use the cursor [
E]/[R] keys to select "ExtDRV" and press
the [ENTER] key.
5.
Insert the ZIP or MO disk (disk number 1) with the
stored project into the drive, and press the
[ENTER] key.
The name of the project to be restored and the new project
number are shown on the display.
If you wish to check the restore source directory, press the
cursor [
W] key.
• If a project backup spans several volumes, make sure
that the first disk inserted is the first disk for that project.
If another disk is inserted, the project name will not be
displayed.
• To change the restore source disk, press the [EXIT] key
and repeat the procedure from step 4.
6.
Turn the dial to select a restore source project, and
press the [ENTER] key.
The indication "LOAD SURE?" appears on the display, to
verify the restore process.
7.
To execute the restore process, press the [ENTER]
key. If you wish to cancel the process, press the
[EXIT] key instead.
When restore starts, the indication "LOAD wait..." appears
on the display.
When the project backup spans several ZIP or MO disks, a
message prompting the user to insert the next disk appears
after data from the first disk have been read.
8.
When the above message appears, insert the next
ZIP or MO disk, and press the [ENTER] key.
The restore operation resumes. The new disk number and
the indication "wait..." appear on the display.
To cancel the operation, press the [EXIT] key to bring up
the indication "CANCEL?" on the screen, and then press
the [ENTER] key.
When a backup spans several media volumes, be sure to
insert the disks in the same order as during backup.
Otherwise correct restore is not possible.
9.
Repeat the above steps until the entire project is
restored.
When the restore operation is finished, the display
indication changes to "LOAD COMPLETE".
10.
To return to the main screen, press the [EXIT] key
several times.
■
Restoring from a hard disk
1.
Verify that the hard disk is properly connected to
the MRS-1044 series.
2.
In the main screen, press the [PROJECT/UTILITY]
key.
3.
Use the cursor [
E
]/[
R
] keys to make the display
indicate "UTILITY BACKUP", and then press the
[ENTER] key.
If the above menu does not appear, the MRS-1044 Series
has not properly recognized the hard disk. Check the
power on/off condition of the hard disk and the SCSI
connection.
4.
Use the cursor [
E
]/[
R
] keys to make the display
indicate "BACKUP LOAD", and then press the
[ENTER] key.
The name of the project to be restored and the new project
