Mix the channels DRUM, BASS, 1 – 6, 7/8, and 9/10 as
desired, for bouncing onto the master track.
1.
In the main screen, press the MASTER status key
several times, until the key is lit in red.
Recording on the master track is now
possible. At the same time, the
[BOUNCE] key also lights up and the
bounce function is activated.
The other channels and effects of the
mixer section continue to operate as
before.
2.
Press the PLAY [
R
] key to play back the song, and
adjust the mixing balance of each track.
While watching the L/R level meters, adjust the DRUM,
BASS, 1 – 6, 7/8 and 9/10 channel faders and the
MASTER faders so that the L/R level meters do not clip.
3.
Press the ZERO [
U
] key to return to the beginning
of the song, and then hold down the REC [
O
] key
and press the PLAY [
R
] key.
Recording on the master track will begin.
• The signal recorded on the master track is the signal after
the MASTER fader (the same signal as supplied at the
[OUTPUT] jacks).
• When an insert effect or send/return effect is used, the
recorded signal reflects effect processing.
4.
When you have finished recording, press the STOP
[
P
] key.
The Bounce function will be turned off.
• When bouncing onto the master track, any previous
content of the master track will be erased. Overdubbing
is not possible.
• Always start bouncing from the beginning of a song. If
recording is started halfway through a song, that position
will become the start of the master track.
Master track playback
To play the recorded master track and check the contents,
proceed as follows.
1.
In the main screen, press the MASTER status key
several times, until the key is lit in green.
When the MASTER status key is lit in
green, all other status keys go out. In
this condition, the other channels are
muted, and all effects are off.
2.
Verify that the counter on the display is at the start
position.
If not, press the ZERO [U] key.
While the MASTER status key is lit in green, all transport
keys except the REC [
O] key operate normally.
3.
Press the PLAY [
R
] key.
The master track is played from the beginning.
You can use the MASTER fader to adjust the volume.
4.
To stop playback, press the STOP [
P
] key.
5.
To return the MRS-1044 series to the normal
condition, press the MASTER status key so that the
key goes out.
Muting of the other channels except the master track and
muting of the rhythm section channels is canceled, and the
other status keys return to the previous condition.
