To start recording, hold down the REC [
O
] key and
press the PLAY [
R
] key.
The REC [
O
] key and PLAY [
R
] key will light, and
recording on track 2 will begin. Record your guitar playing
while listening to the rhythm song and track 1 play back.
When you have finished recording your guitar
performance, press the STOP [
P
] key.
The REC [
O
] key and PLAY [
R
] key will go dark, and
recording will end.
To hear the recorded content, press the ZERO [
U
]
key to return to the beginning of the song, and
press the PLAY [
R
] key.
Tracks 1/2 will be played back together with the rhythm
song. If you want to re-do the recording, repeat steps 2 – 6.
When you are finished recording track 2, use the same
procedure to record other instruments on the remaining
tracks. When you are finished with all recording, save the
project.
Step 4: Mixdown
When you are finished recording all tracks, you can adjust
the volume balance etc. of the rhythm section and recorder
section, and create a finished song.
◆ Preparations ◆
• Connect a master recorder such as an MD or DAT
recorder to the [OUTPUT] (DIGITAL or MASTER)
jacks.
• Load the project that you saved at the end of step
3-2. Alternatively, you can load the project "Sample
3" (number 994) from the hard disk. When the
MRS-1044 is shipped from the factory, this project
contains pre-recorded performances on all tracks.
(For details on loading a project, refer to p.17.) The
track structure of "Sample 3" is shown below.
Here's how to adjust the volume, pan (stereo left/right
position), and EQ for each channel of the mixer section.
Make sure that all status keys (DRUM, BASS, 1 – 6,
7/8, 9/10) are lit green. In addition, press the INPUT
1/2 [ON/OFF] keys to make them go dark.
If the INPUT 1/2 [ON/OFF] keys are turned on, any instruments
connected to the [INPUT 1/2] jacks can also be mixed.
