564048
8
Zoom out
Zoom in
Previous page
1/14
Next page
Press the button Ƹ and then the TIMER key ƻ immediately after that.
The TIMER light and the information display
¹ will start blinking.
Use the adjustment keys
ƺ to set the time at which the heater must ignite.
Use the key (
hour) to set the hours and the key ( min.) to set the minutes
(interval of 5 minutes)
.
After approximately 10 seconds the information display will show CLOCK
again and the TIMER indicator light will light up, indicating that the timer
function has been activated (Fig. H).
The timer will ensure that the room will have been heated to approximately
the required temperature at the set time.
When you want to switch off the heater and ignite it again with the timer, all
you have to do is press the TIMER key
(refer to Section G).
Press the button Ƹ once to clear the timer setting.
If you would like more extensive timer possibilities, we advise you to procure
the Zibro weektimer. This timer is easy to connect with your Zibro Heater, see
ƿ.
G SWITCHING OFF THE HEATER
There are two ways to switch off the heater.
Press the button
Ƹ. The information display will show the CLOCK
signal. Within approximately one minute the flame will have extinguished.
Press the TIMER key ƻ, when you want to switch off the heater and ignite it
again with the timer the next time. This not only switches off the heater, but
it also activates the timer function. Y
ou can change the required time with the
adjustment keys ƺ (refer to Section F).
H THE INFORMATION DISPLAY
The infor
mation display
¹ not only ser
ves as an indicator of the (set) time and
temperatur
e (
Sections C, E, and F), it also indicates any malfunctioning of the
heater. The code on the information display tells you what is the matter:
CODE INFORMATION WHAT TO DO
e - 0 Temperature within the heater too high. Cool-down and re-ignite.
f - 0 Power interrupted. Re-ignite the heater.
e - 1 Faulty thermostat. Contact your dealer.
f - 1 Faulty bur
ner ther
mistor
.
Contact your dealer
.
e - 2 Starting problems. Contact your dealer.
e - 5 T
ipping-over pr
otection. Re-ignite the heater.
e - 6 Poor bur
ning. Contact your dealer.
e - 7 Room temperature If necessary,
above 32
°
C.
r
e-ignite the heater
.
e - 8 Defective booster. Contact your dealer.
e - 9 Air filter dirty; or Clean filter
Fuel pump dir
ty
.
Contact your dealer
.
2
1
4
3
2
1
4
55
H: The TIMER indicator
l
ight indicates that the
timer function has been
s
witched on.
In case of any
malfunctioning the
infor
mation display will
tell you what is the
matter.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zibro SRE 246E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zibro SRE 246E in the language / languages: English as an attachment in your email.

The manual is 0,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Zibro SRE 246E

Zibro SRE 246E User Manual - German - 14 pages

Zibro SRE 246E User Manual - Dutch - 14 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info