Manual Zibro R 263 T (page 67 of 125) (English, German, Dutch, Danish, French, Italian, Swedish, Spanish, Norwegian, Finnish)

564211

Zoom out

Zoom in

1/125

If the left side of the grill has been removed, first insert the flattened upper left

end of the grill into the upper left slot and then insert the other flattened end

intotheloerleftslot(Fig.E).

Fill the removable tank as indicated in Section B.

Insert the batteries into their holder ¹ at the back of the heater (Fig. G).

Ensurethatthepositiveandnegativepolesmatchthe+and-marksindica-

ted on the battery housing.

The floor should be firm and completely level.

Reposition the heater, when it is

not level. Do not correct the situation by placing books or other goods under the

heater.

Please refer to the separate instructions in the carton box for fixing of

the heater.

Your heater is now ready for use.

B FILLING FUEL

Fill the removable tank in a suitable place since there can always be some spillage.

Follow the procedure below:

Make sure that the heater is switched off.

Open the upper lid and lift the removable tank out of the heater (Fig. H).

Note: Some drops may leak from the tank. Put down the removable tank (cap

pointing upwards, handle on floor and screw off the fuel cap.

Fill the removable tank using a fuel pump (refer to fuel pump operation in-

structions.) Make sure that it is in a higher position than the removable tank

(Fig. I). Insert the ribbed hose into the opening of the removable tank.

Check the removable tank fuel gauge while filling the tank (Fig. J). Stop filling

once the gauge indicates that the tank is full. Never overfill the tank, especi-

ally not when the fuel is very cold (fuel expands when it heats up).

Let the remaining fuel in the pump flow back into the jerry can and carefully

remove the pump. Carefully screw the fuel cap back on the tank. Clean off any

spilled fuel.

Check whether the fuel cap is straight and tightened properly. Reinstall the

removable tank in the heater (cap down). Close the lid.

C IGNITING THE HEATER

A new heater may give off some smells for a short while, when it is used for the

first time. You should therefore provide extra ventilation or ignite the heater

out-

side the living room.

When you use the heater for the first time, first put the filled removable tank into

place, and then wait approximately 30 minutes before you ignite the heater. This

allows the glass fibre wick to soak up the fuel. Follow the same procedure when you

have completely burnt up all fuel from the tank, and after the glass fibre wick has

been replaced.

empty full

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Zibro R 263 T in the language / languages: English, German, Dutch, Danish, French, Italian, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 17,11 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Zibro R 263 T Manual

Product: