4
67
G: The TIMER indicator
light indicates that the
timer function has been
switched on.
E ELECTRIC HEATING MODE
Press the electric heating button when the kerosene heating is off. The electric
heating mode operates by itself. The information display will display the operating
time of the electric heating.
Use the adjustment keys ! to select the operating time (1 = 1 hour, 2 = 2 hours,
4 = 4 hours or -- = continuous). Set the operation time and after a while the
information display will be switched to 800. The electric heating is now operating
in a high mode (800W). Press the adjustments keys ! to select the high mode
(800W) or low mode (400W). Press the electric heating button " again, to stop
the electric heating. The electric heating lamp will go out and the clock indication
will be displayed in the display. Due to safety reasons the electric heating will stop
after 8 hours (even in continuous operation).
Switch off the electric heating mode by using the timer function or by pressing the
electric heating button ".
F SETTING THE REQUIRED TEMPERATURE
The temperature setting can only be adjusted, when the heater is burning. Use
the adjustment keys !TO ADJUST THE TEMPERATURE &IRST PRESS EITHER OF THE TWO
keys to switch on the function (the °C mark # will start blinking). Next, adjust the
temperature using the key on the right (!min.) to set the temperature to a higher
setting and the key on the left ("hour) to lower the temperature. Press once to
INCREASE THE VALUE ONE STEP !FTER APPROXIMATELY SECONDS THE # MARK WILL STOP
BLINKING AND THE SETTING WILL BE LOCKED &IG &
The available temperature settings range from 6°C minimum to 28°C maximum.
When the heater has been unplugged (or after a power failure), the temperature
will reset to the factory setting of 20°C.
G USING THE TIMER
The timer allows you to switch on the heater automatically at a preset time.
In order to switch on the timer, the correct time must have been set (refer to
Section C) AND THE HEATER SHOULD BE OFF &OLLOW THE PROCEDURE BELOW
1 Press the
button $AND THEN THE 4)-%2 KEY % immediately after that.
4HE 4)-%2 LAMP AND THE DIGIT # will start blinking.
2 Use the adjustment keys ! to set the time at which the heater must ignite.
Use the key on the left ("hour) to set the hours and the key on the right
(!min.) to set the minutes (interval of 5 minutes).
3!FTER APPROXIMATELY SECONDS THE DIGIT WILL SHOW #,/#+ AGAIN AND THE
4)-%2 LAMP WILL LIGHT UP INDICATING THAT THE TIMER FUNCTION HAS BEEN
ACTIVATED &IG '
4The timer will ensure that the room will have been heated to approximately
the required temperature at the set time.
