4
66
F: The required tempe-
rature on the left, the
measured temperature
on the right.
E: When the 4-digit stops
blinking, the setting has
been locked to the indi-
cated value.
6 Check whether the fuel cap is straight and tightened properly. Reinstall the
removable tank in the heater (cap down). Close the lid.
C SETTING THE CLOCK
It is only possible to set the correct time, when the heater is connected to the
mains and not burning. Use the adjustment keys !TO SET THE TIME &IRST PRESS
either of the two keys to switch on the function (the 4-digit " will start blinking).
Next, set the hours using the key on the left (!hour) and the minutes using the
key on the right ("min.). Press once to increase the value by one step. When you
hold down the key, the value will continue going up, until you release the key
AGAIN !FTER APPROXIMATELY SECONDS THE DIGIT WILL STOP BLINKING AND THE SET-
ting will be locked. 5 minutes after switching off the heater, the information on
the display will disappear and the heater will automatically switch into the stand-
by position.
When the heater has been unplugged (or after a power failure), the time needs
to be set again.
D IGNITING THE HEATER
When used for the first time, a new heater may give out a smell for a short while.
You should therefore provide extra ventilation.
!LWAYS IGNITE THE HEATER WITH THE
button #
. Never use matches or a cigarette
lighter.
Just press the button #TO IGNITE THE HEATER 4HE 0/7%2 LAMP WILL START BLINKING
indicating that the ignition procedure has started. This will take a short while. In
the meantime the electric heating has already started 3 seconds after pressing the
button #.
/NCE THE HEATER IS BURNING THE 0/7%2 LAMP WILL REMAIN LIT BLUE 4HE INFORMATION
display " will show two numbers. The light next to them indicates that these
NUMBERS REFER TO THE TEMPERATURES &IG & 4HE ACTUAL ROOM TEMPERATURE IS
INDICATED BELOW 2//- WHILE THE TEMPERATURE SETTING IS INDICATED BELOW 3%4 4HE
latter can be changed with the adjustment keys (refer to Section E).
Prior to igniting the heater, always check for sufficient fuel in the removable tank.
Igniting the electrical heater
Press the
$
button to ignite the electrical heater. The electric heating lamp will
LIGHT UP RED %LECTRIC HEATING WILL START SECONDS AFTER PRESSING THE
$
button.
The electric heating will stop automatically when the room temperature reaches
the set temperature. The electric heating will restart automatically when the room
temperature drops. By pressing the electric heating button
$
, the electric heating
lamp will go out and electric heating will stop. The electric heating can be turned
off manually. By pressing the electric heating button again, electric heating will
start.
