657583

Zepter PWC-200 - Tuttoluxo 2S Manual

18
Zoom out
Zoom in
Previous page
1/22
Next page
EN
16
3 4
5
1
2
9.2 SIMPLY SYSTEM
TM
No need to store up on bags or filters thanks to the SIMPLY SYSTEM
TM
.
Cleaning the purification tank is all that is required for top TUTTOLUXO 2S
efficiency. At the end of your work, empty the liquid waste of the purification
tank as shown in (Pict. 3). To make this operation easier, the divider inside the
tank can be taken off (Pict. 4) and it is also advisable to remove the nebulizers
(Pict. 5). Rinse tank, divider and nebulisers with abundant hot water and neutral
detergent until all residues and stains on the tank walls have been removed.
WARNING!
We strongly advise, after aspirating liquids or solids, to rinse the water bucket
inside and any accessory used, by emptying the tank and aspirating 1 litre of
cold, clean tap water, repeat this twice. Also, please do not leave any aspirated
liquid inside the tank, to prevent the formation of limescale or moulds, and
consequently bad odours.
WARNING!
When you take off the divider, make sure that it is put back correctly into the proper
guides with its curved side facing forwards and upwards and that it touches the
bottom (otherwise it won’t slide in). Please be careful, these are delicate pieces.
In case one gets broken or lost, immediately ask for a spare part from your Zepter
Service Centre. Do not use the TUTTOLUXO 2S without it. Allow all pieces to dry
or dry them yourself before replacing them in the machine and closing the cover.
Moisture left inside could create mildew and unpleasant odours.
REPLACEMENT OF FILTERS:
Floater Filter (PWC-700-4): Replace yearly or earlier according to condition.
Air Intake Filter (PWC-700-2): Replace yearly or earlier according to condition.
Polyester Filter (PWC-700-1): Replace yearly or earlier according to condition.
Motor Intake Filter (PWC-700-3): Replace yearly or earlier according to condition.
Hepa Filter (PWC-700-5): Replace every 6-12 months.
To inspect the filter, proceed as for replacing the Polyester Filter
1) Remove the grilled cover on the back of the TUTTOLUXO 2S.
The HEPA filter is fitted inside. Place the grilled cover on the floor and
extract the filter as shown.
2) Check the filter state; if there are traces of dust or dirt, replace it.
3) Put the new HEPA filter into place and reassemble the cover,
making sure to properly fit the grilled cover hooks onto the slits on the
appliance body. Once the grilled cover is in place, rotate it upwards for the
final fixing with the stopping tongue.
After some periods of use, should the HEPA filter be torn or damaged, it should
be replaced with a new one from a Zepter Service Centre.
TANK LID WITH FLOAT
Also check efficacy of the Safety Float located on the tank lid. If encrusted
with dirt or mould, this may not function correctly. Check that the float can
move freely within its cage. Rinse the lid with plenty of hot water and neutral
detergent.
… 18 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zepter PWC-200 - Tuttoluxo 2S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zepter PWC-200 - Tuttoluxo 2S in the language / languages: English as an attachment in your email.

The manual is 1,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info