623342

Zennio Z41 Pro Touch Panel Manual

15
Zoom out
Zoom in
Previous page
1/96
Next page
Z41 Pro
http://www.zennio.com Tecnical Support: http://support.zennio.com
15
Hence, the alarm log will contain a listing, in reverse chronological order,
where the name, time and date of every alarm event will be shown. In
addition, the log will show the current status of each of them, which may be:
“ON”: the alarm is still active or has not been acknowledged by the
user.
“OK”: the user has acknowledged the alarm event, but the
corresponding object is still in the alarm state.
“OFF”: the user has acknowledged the alarm event and the
corresponding object has already left the alarm state.
For more information on alarms, see epigraph g) in section 3.4.2.5.
IP Address: in case the device has been connected to an IP network through
an Ethernet cable (see section 1.3), the IP address it has been assigned (if
any) will be shown here.
Software Version: indicator that shows the version of the device firmware
currently installed on the device (see section 1.3.1).
Probe Calibration: control for setting a certain correction over the values
thrown by the internal temperature probe. This way, if the value of the
measurement is found to be slightly over (or below) the actual temperature
due to external factors, the final user will have the option to set an adjustment
of between -5.0ºC and +5.0ºC, in steps of 0.1ºC. In addition, it is possible to
set an initial value for such correction by parameter.
Note: any changes made on the calibration of the internal probe will be
applied beginning with the next measurement performed. Therefore, they
may not be perceived immediately.
Device Pairing: button for entering the device pairing function, which needs
to be run once on every Z41 that is intended to be controlled from a remote IP
application. See ANNEX I. Controlling Z41 Pro Remotely via IP for more
details about controlling Z41 remotely.
The labels of the controls in the Configuration page, as well as the title of the page
itself, are customisable in ETS. Moreover, it is possible to make any of the described
… 15 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zennio Z41 Pro Touch Panel at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zennio Z41 Pro Touch Panel in the language / languages: English as an attachment in your email.

The manual is 2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info