623347

Zennio Roll-ZAS Touch Controller Manual

22
Zoom out
Zoom in
Previous page
1/54
Next page
Roll-ZAS
http://www.zennio.com Technical Support: http://zennioenglish.zendesk.com
22
Internal Temp. Sensor: ZAS includes a built-in temperature sensor with an
associated 2-byte communication object ("[Internal Sensor] Current
temperature"), which shows up when the internal sensor function is enabled
under the General parameter window.
Figure 14. Internal Temperature Sensor.
The following can be parameterised from this screen:
Temperature Sensor Calibration: this option permits performing a
correction (by setting a calibration value, in tenths of a degree) over the
value received from the sensor in case there is a deviation between this
value and the actual room temperature, for whatever reason.
Temperature Sending Period: this is the period time (in tens of a second)
for cyclically sending to the KNX bus the current temperature measure,
through the "[Internal Sensor] Current Temperature" communication
object. The value 0 indicates that the periodical sending is disabled.
Send with a Temperature Change: apart from performing a periodical
sending, ZAS can send the bus the value of the current temperature
whenever it turns to be significantly different from the previous
measurement. Therefore, this field defines the increase/decrease (from 0
to 200 tenths of a degree) that, when exceeded, will trigger this extra
sending. Value “0” disables this function.
Temperature Protection: permits activating the overheat or the overcool
protections, or both. Depending on the selection, one or two
communication objects will be enabled: "[Internal Sensor] Overheating"
and "[Internal Sensor] Overcooling", which will indicate (with the value "1")
if the corresponding limit has been exceeded. It is necessary to define the
overheating or the overcooling limit temperatures (or both), in degrees, as
well as, if desired, a hysteresis value (in tenths of a degree) to prevent the
… 22 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zennio Roll-ZAS Touch Controller at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zennio Roll-ZAS Touch Controller in the language / languages: English as an attachment in your email.

The manual is 0,99 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Zennio Roll-ZAS Touch Controller

Zennio Roll-ZAS Touch Controller User Manual - German - 49 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info