540049
25
Zoom out
Zoom in
Previous page
1/32
Next page
25
PG-006_v01
Installation
GENERAL INSTRUCTIONS
THE MANUFACTURER IS NOT LIABLE FOR
ANY DAMAGE CAUSED BY A FAILURE TO
OBSERVE APPLICABLE STANDARDS AND
REGULATIONS, OR BY INSTALLING THE HOB
BY AN UNAUTHORISED PERSON.
The appliance may be installed only by
a certi ed installation technician.
1
The appliance must be installed in a kitchen meeting the
requirements speci ed by Building Law regulations (Journal
of Law No. 89 item 484). The kitchen:
should have appropriate volume, ensuring that the
maximum thermal load from the installed gas appliances
is not more than 930 W/m³,
should have a minimum height of 2.2 m,
should have supply and exhaust ventilation (allowing at
least 1.5 times exchange of air in an hour),
should have air in ow (if there is no window) through
holes made in external walls, with a minimum area of
0.016 m²,
should have fumes exhaust, e.g. through an operating
chimney duct with a minimum size of 0.14 m.
2
The wall adjacent to the hob should be made of
in ammable materials.
3
In order to limit the negative impact of drafts on the
burners, the hob should not be installed on the window-door
line.
4
Kitchen cabinets must not be mounted directly above the
hob. The distance between the side edges of the hob and
the side edges of the cabinets should be at least 50 mm.
5
To ensure appropriate absorption and exhaust of kitchen
fumes, it is recommended that a ventilation hood is installed.
The distance between the hob and the ventilation hood
mounted above it should be at least 700 mm.
Installation of the hob (Fig. A)
The appliance may be installed only by
a certi ed installation technician.
The dimensions and assembling instructions are presented
in the gures above.
1
Before cutting an opening in the worktop, make sure
that the distance between the rear edge of the hob and the
wall is at least 55 mm. Cut out the opening in the worktop in
accordance with the dimensions.
2
Remove all unattached elements from the hob (pan
supports, burner caps, crowns, etc.).
3
Turn the hob upside down. Cut off 4 pieces of the
appropriate length from the seal, remove the protective tape
and stick them along the hob edges.
4
Place the hob in the opening and press rmly so that the
seal ts closely to the worktop. Fix the hob to the worktop
from the bottom with the use of xing clamps.
The appliance must be installed in accordance with
applicable building regulations regarding the installation
of gas devices in residential facilities.
Make sure the worktop is made of suitable heat resistant
material to avoid deformation due to heat produced by
the hob.
Connecting the gas hob
THE MANUFACTURER IS NOT LIABLE FOR
ANY DAMAGE CAUSED BY A FAILURE TO
OBSERVE APPLICABLE STANDARDS AND
REGULATIONS, OR BY INSTALLING THE HOB
BY AN UNAUTHORISED PERSON.
The hob must be connected to the power and
gas system only by a certi ed installation
technician.
Before proceeding with connecting the hob to
the electrical and gas mains, make sure that
the gas valve is closed.
Before connecting the appliance to the
electrical and gas mains, read the information
on the rating label and in this manual.
CONNECTING THE HOB TO THE GAS MAINS
Before installation, make sure that the local distribution
conditions (gas type and pressure) and appliance
settings are appropriate.
The gas setting conditions for this appliance are given on
the rating label.
This appliance is not to be connected to exhaust pipes.
It should be installed and connected in accordance with
applicable installation regulations. Especially, appropriate
ventilation requirements should be met.
The exible gas pipe should be mounted in such a way
as to not touch any moving parts of furniture (e.g.
a drawer) and should not go through spaces with not
enough room.
After installing the hob, the technician is obliged to check
the tightness of the gas installation.
CONNECTING THE HOB TO THE ELECTRICAL
MAINS
The gas hob is equipped with a power cord
without a plug. The plug should be attached
to the power cord exclusively by a quali ed
electrician.
The socket to which the appliance is to be
connected should be easily accessible to the
user.
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zelmer ZPG6175SZ at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zelmer ZPG6175SZ in the language / languages: English, Polish as an attachment in your email.

The manual is 0,82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info