539690

Zelmer Syrius Manual

44
Zoom out
Zoom in
Previous page
1/50
Next page
50 1600-016_v01
Before operation make sure that the SAFBAG bag is installed
in the vacuum cleaner chamber and that inlet lter and the
HEPA outlet lter is installed in the appliance.
9
Switch on the vacuum cleaner by pressing the “on/off”
button (2).
10
The vacuum cleaner is equipped with an electronic
power control which allows to gradually adjust the vacuum
cleaner suction power during operation. To adjust the
suction power use the power adjustment buttons (10,12)
– to increase the suction power or – to decrease the
suction power. The suction power setting is indicated by the
appropriate number of lit diodes.
Thevacuumcleanerisequippedwithapower
level memory function. When you turn off
thevacuumcleanerusing the ON/OFFbutton
(2), the power level is going to be stored in
memory. After the vacuum cleaner is turned
onnexttime,itisgoingtostartworkingatthe
samepowerlevelithadbeenworkingbeforeit
wasturnedoff.
The suction power may be adjusted during operation.
The recommended settings are:
Setting 1 – vacuuming curtains
Setting 2 – vacuuming upholstery
Setting 3 – cost-effective power
Setting 4 – vacuuming carpets
Setting 5 – vacuuming hard oors and crevices.
The vacuum cleaner is equipped with the
adjustmentfunctionforLEDbrightnessofthe
powerlevelindicator(11)onthecontrolpanel.
In order to set a demanded LED brightness,
youhavetopressbothofthepoweradjustment
buttons (10) and (12), and when still
pressing these buttons turn on the vacuum
cleanerbypressingtheON/OFFbutton(2).The
LEDforpowerlevels1,3,and5turnon,and
the motor stays turned off. Next by pressing
thepoweradjustmentbuttons (10)and
(12)youcanrespectivelyincreaseordecrease
the brightness of power level indicator (11).
After setting a desired LED brightness, it is
necessarytoturnoffthevacuumcleanerusing
the ON/OFF button (2). In this way you leave
theLEDbrightnessadjustmentfunctionmode,
andthesetLEDbrightnesslevelisstored.
11
The vacuum cleaner type 1600.3 is additionally equipped
with remote suction power control located in the suction hose
handle. It allows to change the suction power without the
necessity to bend down.
In order to use this function, open the battery compartment
in the suction hose handle and insert two 1.5 V AAA type
batteries or two chargeable 1.2 V AAA type batteries.
Insert the batteries so that the battery pole
market“+”isalwaysdirectedtowardsthelock
ofthecompartmentmarkedwith“+”.
Use only high quality batteries. Battery leakage may
cause damage to the electronic system.
12
To use the remote control of the suction power press the
appropriate button on the hose handle ( , ):
To increase the suction power by one setting press the –
button.
To decrease the suction power by one setting press the –
button.
13
Press the button on the hose handle to temporarily
switch off the appliance and to operate in the STANDBY
mode.
To continue vacuuming press the STANDBY button (17) once
again. The appliance will start operating with the previously
set suction power.
The infrared transmitter and receiver have to
“see”eachotherinorderfortheremotecontrol
systemtoworkproperly.
14
The vacuum cleaner is equipped with an accessory
compartment. To open the compartment lift the vacuum
cleaner handle and pull the accessory compartment cover
(6) upwards.
15
The accessories may be attached to the accessory
holder in the suction hose handle. This way they will be
available for use at any time.
16
The vacuum cleaner is equipped with the “Parksystem”
function. This function allows to temporarily switch off the
vacuum cleaner using the fastening hook of the combination
brush without the necessity to use the on/off button. In order
to do so, during operation insert the fastening hook of the
combination brush in the combination brush fastening (5).
The vacuum cleaner will automatically switch off.
Filter disassembly
Before changing the lters make sure that the vacuum cleaner
is switched off and unplugged from the mains supply.
INLET FILTER
1
Release the front cover fastening (15) and open the
cover.
2
Slide the inlet lter (20) from the appliance body.
3
Insert the new lter making sure that the outer edge of
the lter is located to the inside of the limiting rib.
4
Close the front cover.
HEPA OUTLET FILTER
The vacuum cleaners are equipped with a HEPA (High
Efciency Particulate Air) H11, H13 outlet lter.
The lters have a high ltration capacity; they are made of
special bers which are able to retain almost all dust particles.
The H11 and H13 classes determine the permeability of
C
D
… 44 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zelmer Syrius at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zelmer Syrius in the language / languages: English, Polish as an attachment in your email.

The manual is 4,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info