538803

Zelmer SB1000 Manual

42
Zoom out
Zoom in
Previous page
1/44
Next page
48 SB1000-001_v01
You can use the “ICE” programme to crush ice. This function
allows to obtain small pieces of ice of similar size.
Make sure that the stand blender is clean before
using it to crush ice. Should it be dirty, wash it
thoroughly with clean water. Any washing-up
liquid residues may affect the taste of the
crushed ice and the taste of a drink, to which
such ice will be added.
To obtain the best results of running the appliance in the
“ICE” mode, use 10-25 ice cubes per load (the cubes
should not be bigger than 2 cm in size). Add also ca. 15
ml (1 teaspoonful) of cold, fresh water. Place the jug lid
and insert the stopper, and then press the “ICE” button to
run the appliance in the momentary work mode (it will run
in cycles for 6-7 seconds with 6-7-second intervals). When
the appliance has completed ca. 5 crushing cycles, press
the “ICE” button again to stop the appliance. If you are still
dissatised with the results of crushing, because you want
the ice to look like snow, press and hold the “TURBO”
button for a couple of seconds.
Always pour some water into the jug before
you start crushing ice.
Immediately after the crushing of ice or use
a mixer with loads of ice do not wash the
blender pitcher in hot water, because a large
temperature difference can break the glass.
After operation
When the appliance is no longer in use, switch it off pushing
the ON/OFF button .
Use one hand to hold the motor unit
●
(1) and the other
one to grab the jug holder (6).
Turn the jug anticlockwise, so that the protruding element
●
on the jug base ts in the cut-out in the motor unit.
Remove the blender jug from the motor unit.
Remove the lid
●
(7) from the blender jug (5), pulling the
locked stopper with level indication.
Unplug the appliance from the mains socket if you do not
●
intend to use it any longer.
Grinder
C
The grinder has been designated for grinding and milling
of such ingredients as pepper, coffee beans, rice, wheat,
sesame seeds, nuts (shelled), etc., as well as for chopping
meat.
The grinder has not been designated for
grinding down very hard ingredients such as
ice cubes or nutmeg.
Never use the grinder for grinding sugar as this
may damage the appliance.
6
Put ingredients into the blender jug (5). Do not exceed
the 1500 ml line on the blender jug. If the line is exceeded,
the content of the jug may raise jug lid (7) when the motor
is on.
The way you insert the ingredients into
a blender’s jug is free, but better results are
obtained by adding the hard components at
rst.
7
Place the lid (7) onto the jug (5) before use so that its
protruding element ts in the cut-out in the jug. Press the lid
hard.
Moisten the sealing ring with water before
placing the lid (7).
8
Insert the lid stopper (9) into the opening in the lid.
Protruding elements on the lid stopper must t in the cut-outs
in the jug lid.
9
Turn the cover cap (9) in the clockwise direction until it is
locked.
Do not start the stand blender without the lid
stopper (9) in place, especially if you want
to blend solid ingredients, as they might be
ejected through the opening.
10
Select the required blade rotation speed using “–” and
“+” buttons. 1 to 5 diodes will illuminate depending on the
selected speed.
11
Start the appliance, pressing the ON/OFF button .
The button will start blinking.
After 2 minutes of work stop operation of
appliance for at least 1 minute, allowing the
engine to cool down. The process of mixing can
have a maximum of ten two-minute work cycles.
12
When the appliance is no longer in use, switch it off using
the ON/OFF button .
QUICK START PROGRAMMES
Press the required button to use one of
the three available quick start programmes
(“PULSE”, “ICE”, “TURBO”).
13
“PULSE”
Pressing the “PULSE” button will cause the appliance to
run in the momentary work mode (it will run in cycles for 6-7
seconds with 6-7-second intervals) at a preset speed. To
stop the appliance, press the “PULSE” button again.
14
“TURBO”
The appliance will start processing ingredients at a maximum
speed, if the “TURBO” button is pressed and held. To stop
the appliance, release the “TURBO” button. The appliance
will stop immediately.
15
“ICE”
… 42


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zelmer SB1000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zelmer SB1000 in the language / languages: English, Polish as an attachment in your email.

The manual is 0,86 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Zelmer SB1000

Zelmer SB1000 Additional guide - English, Polish - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info