539210
54
Zoom out
Zoom in
Previous page
1/54
Next page
58 AH1500-001_v01
4
The basis of the humidier turn so that the side with the
control panel was lying on the ground.
5
Press the catch located in the lter cover and pull the
inlet lter from the base of air humidier.
Rinse the lter under running water. Before
re-assembling be sure to dry the lter.
6
Place the inlet lter in the previously occupied space,
attach the lter cover and press it down rmly.
Turn the humidier’s base to the natural position. Place the
water tank by putting it on the base of the humidier. Mount
the steam jet on the water tank. Water begins to overow to
the base of the humidier.
Troubleshooting
Check the below listed comments and notices before requesting service.
PROBLEM POSSIBLE CAUSE REMEDY
The display and operation indicators are not
working, no haze and air blow.
The appliance is not plugged into a wall
outlet.
Plug the cord into an electrical outlet.
No power to the appliance. Check electric circuit – fuses.
The appliance is on, no haze and air blow. The water level in the tank for water has
fallen below the required.
Fill the water tank.
Too low humidication level is set. Check electric circuit – fuses.
Too much water in the base of humidier. Fill the water tank.
Float switch is jammed. Remove the water tank from the base and
unlock the oat switch.
If the indoor humidity level is higher than
85% RH, it will stop producing steam and
the display shows “H% RH”.
When the level of humidity in the room
drops to 60% RH the appliance resumes
production of steam.
The appliance emits an unpleasant odor. The new appliance. When you turn on and use the appliance for
the rst time, there may be present a specic
odor. This is not a threat, or does not indicate
a malfunction of the appliance. The smell
should cease after repeated use.
Remove the water tank from the base of the
humidier and leave an open tank for at least
12 hours.
The water in the tank water is not clean or
has not been changed for a long time.
Clean the water tank and humidier base,
ll with clean water.
Humidier does not produce enough steam. The ultrasonic transducer was covered with
deposited scale.
Clean the ultrasonic transducer.
The water in the tank water is not clean or
has not been changed for a long time.
Clean the water tank and humidier base,
ll with clean water.
Strange noises during appliance operation. A resonance resulting from low water level in
the water tank.
Fill the water tank.
The appliance is located on an unstable
surface.
Place the appliance on a stable, at surface.
A mist comes out around the jet. The gap between the jet and container. Soak the jet in the water for a while, and
then mount it on the appliance.
54


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zelmer AH1500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zelmer AH1500 in the language / languages: English, Polish as an attachment in your email.

The manual is 2,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info