538860

Zelmer 491 Symbio Manual

50
Zoom out
Zoom in
Previous page
1/54
Next page
54 491-007_v01
Before shredding big pieces of the products
cut them into smaller ones – approximately
1 cm cubes.
Never disassemble the lid from the container
before the disc stops rotating.
Operational guidelines
The dismantling process should be done in reverse order
●
to assembly.
The operating time of the blended equipped with the food
●
processor cannot exceed 2 minutes. Allow the motor to
cool before proceeding.
Do not start – up the motor without accessories.
●
When nished, turn the appliance off and unplug it by
●
disconnecting the cable cord from the power outlet.
If the products stick to the blade or the walls of the
●
container:
Switch off the appliance. –
Remove the drive with the lid and container of ice or –
other products crusher.
Remove the products out of the mini food processor –
walls.
Re-assemble the appliance – as dened above, –
Continue the operation.
Approximate time for processing of selected
products for the recommended gear
Product
Recommended
gear
Processing
time
TURBO 20-30 s
TURBO 25-30 s
1/4
8-10 15 s
15
+TURBO
40 s + 5 s
( ×30)
15 10 s
15
+TURBO
15 s + 5 s
TURBO 30 s
You can shorten the processing time as you wish, then you
obtain other granulation of grinded products.
OPERATING THE FOOD PROCESSOR
The appliance characteristics
ZELMER Hand blender is equipped with a food processor
which is used for chopping, liquidizing, slicing, and grating
fruits and vegetables.
The application of the food processor accessories
Double – sided slicing disc – is used to slice fruit and
vegetable (raw, boiled) into thin or thick slices. The slicing
disc is round, with double -sided blades (one side for thin
slices, the other side for thick slices).
Double – sided chipping and puree disc – is used for
chipping and pureeing fruit and vegetables. Chipping and
puree disc is round, with double -sided blades (one side for
chipping i.e. carrots, celery boiled beetroots, the other side
for pureeing – i.e. for potato pancakes, beetroot salad).
Disc driver – is used for assembling discs (for slicing,
chipping and pureeing).
Pusher – is used for pushing product grinded with all discs
and closing the lid feed chute.
Use permanent guard for all shields of the food
processor.
The slicing and pureeing process cannot last
longer than 2 min. After this time, wait until
the motor cools down before next usage of the
blender.
Preparing the food processor to use
Before assembling on and removing the blender
drive out of the food processor, make sure that
the plug of the supplying cord is disconnected
from the mains supply outlet.
Wash the parts in contact with processed product before
rst usage.
Operate the blender so, that the closed/open markings
located on the appliance are well visible.
Operating the food processor (Fig. E)
1
Place the base of the food processor on rm, at and
dry surface. Insert the food processor container into the base
fasteners.
2
Lock the container.
Operation with food processor (slicing disc,
chipping and puree disc) (Fig. F)
1
Place the selected disc on the disc driver (double-sided
discs) so that the blades provided for operation are on
the top.
2
Insert the accessory inside the container, so that it is
connected with the drive shaft.
3
Insert the permanent guard. The guard can be assembled
200 g
(500 ml)
20 g
(500 ml)
300 g
300 g
(500 ml)
250 g
(500 ml)
200 g
(500 ml)
1 cm
1 cm
250-300 g
(400-500 ml)
… 50 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zelmer 491 Symbio at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zelmer 491 Symbio in the language / languages: English, Polish as an attachment in your email.

The manual is 2,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info