517530
17
Zoom out
Zoom in
Previous page
1/36
Next page
17
User’s manual
EN
7. Fasten the station (N) to the ground with the pegs (P). If necessary,
fasten the base with the screw anchors (Q).
pegs (P)
screw anchors (Q)
charging station (N)
8. Replace the protection (L).
9. Connect the power cord (E) of the charging station (N) to the transmitter (B).
10. Connect the plug of the power supply unit (A) to the electrical outlet.
11. If the led (H) ashes,the connection is correct. If not, search for the fault (see “Troubleshooting Guide”).
protection (L)
current power
supply unit (A)
power cord (E)
Perimeter
wire
charging station
transmitter (B)
led (H)
H. min. 160 cm
(63.00 ")
BATTERY CHARGE ON FIRST USE
1.
Place the robot inside the charging station.
2. Press the ON key.
3. After a few seconds, the message “CHARGING” will appear on the
display.
4. Press the “Start/Pause” key. The “PAUSE” function appears on the
display. The batteries start the charging cycle.
5. At the end of the charging, the robot can be programmed for the initial
start-up (see “Programming Mode”).
“ON” KEY “START/PAUSE” KEY
Important
On rst recharge, the batteries must remain connected for at least 24 hours.
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ZCS 9L2BL at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ZCS 9L2BL in the language / languages: English as an attachment in your email.

The manual is 10,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of ZCS 9L2BL

ZCS 9L2BL User Manual - Dutch - 56 pages

ZCS 9L2BL User Manual - Dutch - 33 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info