17
13. Cancelling a programme
Turn the selector dial to position «Off» to cancel a
programme which is running. Now you can select a
new programme.
14.How to open the door during
the cycle of a programme
You can open the door, after having set the washing
machine to PAUSE phase, by pressing “Start/Pause”
button provided the following conditions exist:
1) the washing machine is not in the heating phase
beyond 55°C
2) the level of the water is not high;
3) the drum is not turning.
After approximately 3 minutes, you can open the
door.
Pay attention to the level and temperature of the
water in the washing machine!
15. End of programme
The washing machine stops automatically at the end
of the programme giving an audible signal.
If the Rinse hold option has been selected, the
LED of the “Start/Pause” button goes off, the LED
and the “End” LED remain lit to indicate that the water
must be drained before opening the door. The
display shows a flashing zero.
To empty out the water you can select programme
“Drain”, the water is emptied out without spinning or
select programme “Spin” or “Delicate Spin”. Select the
spin speed by means of the relevant button and then
press the “Start/Pause” button.The water is emptied
out and the laundry is spun at the selected spin
speed.
Turn the programme selector dial to position «Off» to
switch the machine off.
Remove the laundry from the washing machine.
Check whether the drum is completely empty, by
rotating it with your hand. The purpose of this is to
prevent any items of laundry from remaining
accidentally in the drum, where they might get
damaged in a subsequent wash (e.g. by shrinking) or
bleed colour into another load of laundry.We advise
you to close the water supply tap and disconnect the
plug from the socket.Leave the door ajar in order to
air the washing machine.
