649510
19
Zoom out
Zoom in
Previous page
1/24
Next page
Return machine to it's upright position and re-
move the power supply cable and the drain-
ing and inlet hose from the hose holders on
the rear of the appliance.
With a suitable spanner unscrew and remove
the three screws and their spacers on ma-
chine's rear.
The three holes must
then be plugged with
the plastic plug caps
supplied in the bag
containing the in-
struction booklet,
which can be found
inside the drum.
Positioning
Install the machine on a flat hard floor. Make
sure that air circulation around the machine is
not impeded by carpets, rugs etc. Check that
the machine does not touch the wall or furni-
ture. Level the washing machine by raising or
lowering the two front feet. If necessary, check
the setting with a spirit level. Any necessary ad-
justment can be made with a spanner. Accurate
levelling prevents vibration, noise and displace-
ment of the machine during operation.
Caution! Never place cardboard, wood or
similar materials under the machine to
compensate for any unevenness in the floor.
Water inlet
Warning! This appliance must be
connected to a cold water supply
Caution! Before connecting up the
appliance to new pipework or to pipework
that has not been used for some time, run off a
reasonable amount of water to flush out any
debris that may have collected
Caution! Do not use the hose from your
previous appliance to connect to water
supply.
Connect the hose to
a tap with a 3/4”
thread. Always use
the hose supplied
with the appliance.
The machine end of
the inlet hose can be
turned in any direc-
tion. Set the hose
correctly by loosening
the ring nut. After po-
sitioning the inlet
hose, be sure to
tighten the ring nut
again to prevent
leaks.
19
www.zanussi.com
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zanussi ZWC1301 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zanussi ZWC1301 in the language / languages: English as an attachment in your email.

The manual is 2,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info