303728
15
Zoom out
Zoom in
Previous page
1/68
Next page
The feet must never be removed. Do not restrict the
floor clearance through deeppile carpets, strips of
wood or similar. This might cause heat built-up which
would interfere with the operation of the appliance.
Important!
The hot air emitted by the tumble dryer can reach tem-
peratures of up to 60°C. The appliance must therefore
not be installed on floors which are not resistant to
high temperatures.
When operating the tumble dryer, the room tempera-
ture must not be lower than +5°C and higher than
+35°C, as it may affect the performance of the appli-
ance.
Should the appliance be moved, it must be transported
vertically.
The appliance must not be installed behind the lock-
able door, a sliding door a door with a hinge on the
opposite side to that of the appliance in such a way that
a full opening of the dryer is restricted.
Removing transport safety packaging
Caution! Before use all parts of the transport
packaging must be removed.
1. Open loading door 2. Pull off adhesive strips
from inside machine on
top of drum.
3. Remove foil hose and polystyrene padding from the
machine.
Electrical connection
Details on mains voltage, type of current and the fuses
required should be taken from the type plate. The type
plate is fitted near the loading aperture (see “Product de-
scription” chapter).
Warning! The manufacturer declines any
responsibility for damage or injury through failure
to comply with the above safety precautions.
Should the appliance power supply cable need to be
replaced, this must be carried out by our Service Center.
Warning! The power supply cable must be
accessible after installing the machine.
Door reversal
To make it easier to load or unload the laundry, the door
can be reversed.
Warning! The door must only be reversed by an
authorised service engineer.
Please contact your local Service Force Centre. The en-
gineer will carry out the door reversal at your cost.
Special accessories
stack kit
Available from your Service Force Centre or your
specialist dealer
These intermediate installation kits can be used to ar-
range the dryer and an washing machine (60 cm wide,
front loaded) as a space-saving washer/dryer stack.
The washing machine is at the bottom and the dryer is
at the top.
Read carefully the instructions supplied with the kit.
drain kit
Available from your Service Force Centre or your
specialist dealer
Installation kit for direct draining of condensate into a
basin, siphon, gully, etc. The condensate tank then no
longer has to be drained, it must however remain in its
intended position in the machine.
Read carefully the instructions supplied with the kit.
pedestal with the drawer
Available from your Service Force Centre or your
specialist dealer
15
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zanussi zte 273 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zanussi zte 273 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 6,34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info