447616

Zanussi ZFT 710 W Manual

15
Zoom out
Zoom in
Previous page
1/48
Next page
Service
• Any electrical work required to do the servicing of the
appliance should be carried out by a qualified electri-
cian or competent person.
• This product must be serviced by an authorized Service
Centre, and only genuine spare parts must be used.
Environment Protection
This appliance does not contain gasses which could
damage the ozone layer, in either its refrigerant cir-
cuit or insulation materials. The appliance shall not be
discarded together with the urban refuse and rubbish. The
insulation foam contains flammable gases: the appliance
shall be disposed according to the applicable regulations
to obtain from your local authorities. Avoid damaging the
cooling unit, especially at the rear near the heat exchang-
er. The materials used on this appliance marked by the
symbol
are recyclable.
Control panel
1 2 3 4 5
1 Green Indicator Light
2 Red Indicator Light
3 Yellow Indicator Light
4 Freezer Switch
5 Temperature Regulator
Switching on
1. Allow the appliance to stand for 4 hrs after installa-
tion.
2. Insert the plug into the wall socket.
3. Turn the Temperature Regulator clockwise to a medi-
um setting.
4. The Green Indicator Light will light up and remain lit
until the appliance is switched off at the mains.
5. Press the Freezer Switch to activate the fast-freeze
function (Yellow Indicator Light will illuminate) and
leave to run for 4 hours to allow the correct tempera-
ture to be reached before placing food inside.
Yellow Indicator Light lights in the switched-on state
of the Freezer Switch.
6. The Red Indicator Light will also illuminate until the
correct temperature is reached.
A few hours after starting up the Red Indicator Light
will go out to show that the correct temperature has
been reached for the setting chosen and will stay out
to indicate that everything is in order. It will come on
if the freezer temperature rises unduly for instance,
after opening the freezer door or placing food inside
the cabinet, but the light should go out again when
the temperature returns to the correct storage level.
7. When the appliance has reached the set temperature
(the Red Indicator Light has gone out) press the
Freezer Switch again to switch off the fast freeze
function. The Yellow Indicator Light will go out.
Switching off
1. To turn off the appliance, turn the Temperature Reg-
ulator to the "O" position.
2. To disconnect the appliance from the power discon-
nect the mains plug from the wall socket.
Temperature regulation
The temperature within the appliance is controlled by the
Temperature Regulator situated on the control panel.
To operate the appliance, proceed as follows:
15
… 15 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zanussi ZFT 710 W at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zanussi ZFT 710 W in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,59 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info