649494
12
Zoom out
Zoom in
Previous page
1/20
Next page
The programme can no longer be changed directly
once the programme has started. If nevertheless
there is an attempt to change the programme on the pro-
gramme knob, the programme progress display and the
maintenance indicators flash. If an option button (exclud-
ing the
BUZZER button) is pressed, appears on
the display. The drying programme is not however affec-
ted by this (laundry protection).
Drying cycle complete / removing laundry
Once the drying cycle is complete, the display shows the
anti-crease icon and flashing as well as warning
lamps: FILTER and TANK . If the
BUZZER button has
been pressed, an acoustic signal sounds intermittently for
about one minute.
The drying cycles (except from the WOOL pro-
gramme) are automatically followed by an anti-
crease phase which lasts around 30 minutes. The drum
rotates at intervals during this phase. This keeps the laun-
dry loose and free of creases. The laundry can be removed
at any time during the anti-crease phase. (The laundry
should be taken out towards the end of the anti-crease
phase at the latest to prevent creases from forming.)
1. Open door.
2. Before removing the laundry, remove fluff from the
micro-fine filter. It is best to use a damp hand for
this purpose. (See “Cleaning and maintenance”
chapter.)
3. Remove laundry.
4.
Turn the programme selector to
off.
5. Close the door.
After each use
Clean the filters.
Empty the water reservoir.
Cleaning and maintenance
Cleaning lint filters
To ensure that the appliance works perfectly, the lint filters
in the door and in front of the drum must be cleaned after
every drying cycle.
Caution! Important. Never operate the dryer without
the lint filter or with a damaged or blocked lint filter.
1. Open loading door 2. After a period of time, a
patina due to detergent
residue on laundry forms
on the filters. Then clean
the filters with warm water
using a brush. Remove the
filter from the door pulling
it out.
3. Use a damp hand to
clean the micro- fine filter,
which is built into the low-
er part of the loading aper-
ture.
4. Remove fluff from lint
filter, preferably using a
damp hand for this pur-
pose.
Replace the filter.
Cleaning heat exchanger
Clean the condenser when light Condenser comes on.
The condenser is situated at the lower part of the cabinet
behind a small door.
12
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zanussi ZDC68560W at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zanussi ZDC68560W in the language / languages: English as an attachment in your email.

The manual is 3,14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info