528942
16
Zoom out
Zoom in
Previous page
1/32
Next page
Daily Use
Load the laundry
Open the door by careful-
ly pulling the door handle
outwards. Place the laun-
dry in the drum, one item
at a time, shaking them
out as much as possible.
Close the door.
Make sure that no laun-
dry stays between the
seal and the door. There
is a risk of water leakage
or damage to the laun-
dry.
Measure out the detergent and the fabric softener
Pull out the dispenser drawer until it stops. Measure
out the amount of detergent required, pour it into the
main wash compartment
or in the appropriate
compartment if the selected programme/option it re-
quires (see more details in "Detergent dispenser
drawer").
If required, pour fabric softener into the compartment
marked
(the amount used must not exceed the
«MAX» mark in the drawer). Close the drawer gently.
Select the required programme by means of the
programme selector dial (1)
Turn the programme selector dial to the required pro-
gramme.
The green pilot light of button 7 starts to flash. The se-
lector dial can be turned either clockwise or anticlock-
wise.
Turn the selector dial to position to reset the pro-
gramme/to switch the machine OFF.
At the end of the programme the selector dial must
be turned to position
, to switch the machine
off.
Important! If you turn the programme selector dial to
another programme when the machine is working, the
red pilot light of button 7 will blink 3 times and the
messageErr is displayed to indicate a wrong selection.
The machine will not perform the new selected
programme.
Select the spin speed by pressing button 2
When selecting a programme, the appliance proposes
automatically the maximum spin speed provided for
that programme. (See "Washing programmes" for the
maximum allowed spin speed).
Press this button repeatedly to change the spin speed,
if you want your laundry to be spun at a different speed.
The relevant pilot light illuminates.
Select the available options by pressing the buttons
5 and 6
Depending on the programme, different options can be
combined. These must be selected after choosing the
desired programme and before starting the programme.
When these buttons are pressed, the corresponding pi-
lot lights illuminate. When they are pressed again, the
pilot lights go out. If an incorrect option is selected, the
integrated red pilot light of the button 7 flashes 3 times
and the message Err is displayed.
For the compatibility among the washing programmes
and the options see chapter «Washing programmes».
Start the programme by pressing button 7
To start the selected programme, press this button; the
corresponding green pilot light stops blinking.
The pilot light 9 illuminates to indicate that the appli-
ance starts operating and the door is locked.
If you have chosen a delayed start, the machine will be-
gin the countdown.
Important! If an incorrect option is selected, the
message Err is displayed for a few seconds and the
red pilot light of this button blinks 3 times.
16
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zanker WTF968A.8 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zanker WTF968A.8 in the language / languages: English as an attachment in your email.

The manual is 3,16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Zanker WTF968A.8

Zanker WTF968A.8 User Manual - German - 36 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info