669702
17
Zoom out
Zoom in
Previous page
1/40
Next page
16
1.
When the flight altitude of the aircraft is lower
t
han the desired altitude, it will climb to the desired
altitude
vertically first, then fly back at the current
altitude
and descends vertically within 13-26ft(4-8m)
of the pilot until it automatically lands.
2.
When the flight altitude of the aircraft is higher
t
han the desired altitude, it will fly back at the
curr
ent altitude, then descend vertically within
13-26ft
(4-8m) of the pilot until it lands
automaticall
y.
Befo
re switching to Home Mode, press the Setting
Calibration
button on the right task column. Select
Home
Altitude and set a altitude as the desired
altitude, and then Home Mode can be activated. The
flight path is as follows:
If H920 PLUS loses the link with the ST16 Ground Station, it will automatically enter
Home Mode.
NOTICE:
If the Ground Station signal is lost, H920 PLUS will automatically return to
home point and hold its position (with a suitable GPS signal/lock) over the home
position (except in instances of low battery, where it will land itself).
PILOT LOCATION
LANDING
LOCATION
8m�(HOME)�
Horizontal�Distance�from�Pilot
Pilot
ADDITIONA
L FUNCTIONS:
If the PAN mode of the gimbal camera is switched to Follow and Follow Pan Controllable
modes, the gimbal TILT angle will be adjusted as the same as the angle what the gimbal
camera is at each waypoint after the pilot set the waypoints automatically and continuously.
When the PAN mode is switched to the Global Mode, the PAN and TILT angle can be
controlled by aileron and elevator stick.
N
OTICE: The direct distance between every two waypoints should be more than 16 ft./5 meters.
T
as k MODES
Ta
p the TASK/CAMERA icon, the background of 'TASK' will become orange, then the menu
opens
another interface displaying functions: WAYPOINT, CCC (Curve Cable Cam),
Journe
y, POI (Point of Interest), ORBIT ME and TAKE OFF.
16
Wenn der H920 PLUS die Verbindung zur ST16 Ground Station verliert, wechselt er automatisch in
den Home-Modus.
HINWEIS: Wenn der H920 PLUS das Signal der Ground Station verliert, kehrt er automatisch zum
Home-Punkt zurück (sofern ein ausreichendes GPS-Signal anliegt) und hält seine Position über der
Home-Position (außer bei geringer Akkuladung, dann landet er selbsttätig).
Drücken Sie die Kalibrierungstaste („Setting Calibration“) in der
rechten Task-Spalte, bevor Sie in den Home-Modus schalten.
Wählen Sie „Home Altitude“ und stellen Sie die gewünschte
Höhe ein, dann kann der Home-Modus aktiviert werden. Der
Flugweg sieht wie folgt aus:
1. Wenn die Flughöhe des Fluggeräts geringer ist als die ge-
wünschte Höhe, steigt es zuerst auf die gewünschte Höhe, iegt
dann auf der aktuellen Höhe zurück und sinkt dann in 4 bis 8m
Entfernung vom Piloten vertikal, bis es schließlich automatisch
landet.
2. Wenn die Flughöhe des Fluggeräts höher ist als die gewünsch-
te Höhe, iegt es auf der aktuellen Höhe zurück und sinkt dann
in 4 bis 8m Entfernung vom Piloten vertikal, bis es schließlich
automatisch landet.
LANDEPLATZ
STANDPUNKT
DES PILOTEN
Horizontaler Abstand zum Piloten
ZUSÄTZLICHE FUNKTIONEN:
TASK-MODI
Tippen Sie auf das „TASK/CAMERA-Symbol, wodurch der Hintergrund des „TASK“-Symbols orange
wird. Dann wird ein neuer Bildschirm geöffnet, auf dem die folgenden Funktionen angezeigt werden:
WAYPOINT, CCC (Curve Cable Cam), Journey, POI (Point of Interest), ORBIT ME und TAKE OFF.
CCC: (Curve Cable Cam) Mit Curve Cable Cam können Sie Flugrouten/Flugmissionen
erstellen, die der H920 PLUS abiegen soll. Sobald der Pilot die Punkte festgelegt hat,
iegt der H920 PLUS die festgelegten Koordinaten ab und hält dabei den Kurs.
Wenn der Modus PAN (Schwenken) der Gimbal-Kamera in den Follow und Follow Pan Controllab-
le Mode geschaltet ist, wird der Neigungswinkel der Gimbal jeweils an den Winkel angepasst, den
die Gimbal-Kamera an jedem Wegpunkt hat, nachdem der Pilot die Wegpunkte automatisch und
durchgehend eingestellt hat. Wenn der PAN-Modus in den Global-Modus geschaltet wird, können
der Schwenk- und der Neigungswinkel mit dem Querruder- und dem Höhenruder-Hebel gesteuert
werden.
HINWEIS: Der direkte Abstand zwischen zwei Wegpunkten sollte mehr als 5 m betragen.
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yuneec Tornado H920 Plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yuneec Tornado H920 Plus in the language / languages: German as an attachment in your email.

The manual is 3,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Yuneec Tornado H920 Plus

Yuneec Tornado H920 Plus Quick start guide - English - 2 pages

Yuneec Tornado H920 Plus User Manual - English - 40 pages

Yuneec Tornado H920 Plus Quick start guide - German - 2 pages

Yuneec Tornado H920 Plus User Manual - French - 40 pages

Yuneec Tornado H920 Plus Quick start guide - French - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info