669800

Yuneec Tornado H920 Industry Manual

32
Zoom out
Zoom in
Previous page
1/39
Next page
CHARGING THE BATTERY
Connect the Power Connector and Balancing Connector to the charger.
STEP 1) BATT/PROGRAM Select.
Press INC and DEC to go through all the programs and press START/ENTER to enter
Li-Io BATT Program.
STEP 2) Mode Select
Press INC and DEC to go through all the modes and press START/ENTER to enter Li-Io
Balance Charge Mode.
STEP 3) Battery Setting
Press START/ENTER, the current value will start to blink, then press INC or DEC to
increase or decrease the value. After confirming your setting, press START/ENTER. For
the Proaction™ battery, it is recommended to set 1.8A (no more than 2A).
The battery cells number will start blinking, press INC and DEC to increase or decrease
the value, and then press START/ENTER to confirm your setting. For the ProAction™,
4S should be selected.
STEP 4) Program Start
Press and hold START/ENTER for 3 seconds to start the program. The charger is
detecting the battery cell and "BATTERY CHECK" will be on the screen
(the third block) R shows the number of cells detected by the charger and S is the
number of cells set by you at the previous screen. If the numbers are not identical,
press STOP to go back to the previous screen to recheck the number of cells of the
battery pack before proceeding the next step.
(the fourth block) R shows the number of cells detected by the charger and S is the
number of cells set by you at the previous screen. If the numbers are identical, press
START/ENTER to start charging. It will take approximately 2 hours to charge a fully
discharged (not over-discharged) battery. When the charging process finishes, "END:
FINISH" will be on the screen.
STEP 5) Charging Status Monitor
During charge process, real-time status will be shown as the left screen.
During the charging process, press STOP to stop the charging process.
31
… 32 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yuneec Tornado H920 Industry at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yuneec Tornado H920 Industry in the language / languages: English as an attachment in your email.

The manual is 3,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info